MEDLINE MDS80615T Trapeze Bed Mount Kit Trapeze Base Installation Guide
- June 7, 2024
- MEDLINE
Table of Contents
MDS80615T
MDS80616T
(250 lb.)
Trapeze Bed Mount Kit
Trapeze Base
INSTALLATION / ASSEMBLY INSTRUCTIONS
NOTE : Check all parts for shipping damage. In case of shipping damage, DO NOT use. Contact carrier/dealer for further instruction.
WARNING
DO NOT assemble or use this equipment without first reading and understanding this instruction sheet. If you are unable to understand the Warnings, Cautions or Instructions, contact a healthcare professional, dealer or technical personnel before attempting to install this equipment; otherwise, injury or damage may occur. After assembly and BEFORE use, ensure that ALL attaching hardware is securely tightened. If, for any reason, a proper fit-in installation cannot be achieved, do not use and contact the retailer where purchased for return instructions. Trapeze bar is intended to provide balance and support to a patient; it is NOT intended to support an individual’s full body weight. Using bar to support full body weight may result in product damage and personal injury.
ATTACHING TRAPEZE TO FLOOR BED/BASE END
BED END – Locate the lower bed bracket in the center of the bottom bed frame
with the tubular hook facing up. Secure the wing nuts to anchor lower bed
bracket onto the bottom bed frame.
Base Assembly
Insert the upper base tube into the two sets of lower floor base tubes until the spring pins are locked and rest them on the ground as the figure shows. This is the lower base assembly.
Installing Upper Trapeze Section
1. Set the trapeze on a flat surface for easy installation of the op bed
bracket.
2. Loosen the wing nuts on the top bed bracket and push the bracket
approximately ¾ of the way up on the offset bar.
3. Tighten the wing nuts just enough to hold the top bed bracket in place on
the offset bar.
4. Place the trapeze assembly into the socket of the bottom bracket and
position the tubular hook of the bed bracket so that it rests on the top rail
of the floor bed/base end.
5. Securely tighten the wing nuts to anchor the top bed bracket to the top
rail of the floor bed/base end.
6. Adjust the position and/or height of the trapeze.
ADJUSTING THE TRAPEZE
Height
1. Place any of the lower chain links onto the “S” hook.
Position
1. Loosen the trapeze key by turning counter-clockwise.
2. Push the clamp to preferred location on the offset bar
3. Secure the trapeze clamp to the offset bar by turning key clockwise.
LIMITED WARRANTY
Your Medline brand product is warranted to be free of defects in materials and workmanship for a period of three (3) years from the date of purchase. This device was built to precise standards and carefully inspected prior to shipment. This limited warranty is an expression of our confidence in the materials and workmanship of our products and assures years of convenient, dependable service. In the event of a defect covered by this warranty, we will, at our option, repair or replace the device. This warranty does not cover device failure due to owner misuse or negligence, or normal wear and tear. The warranty does not extend to non-durable components, such as rubber accessories, which are subject to normal wear and replacement. Non-durable components are warranted for 6 months. If you have a question about your Medline product or this warranty, please call us at 1-800-MEDLINE.
www.medline.com
1-800-MEDLINE
©2020 All rights reserved. Medline is a registered
trademark of Medline Industries, Inc.
Medline Industries, Inc., Three Lakes Drive, Northfield, IL
60093 USA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>