Kogan Slim Tilt Adjustable Wall Mount User Guide

June 7, 2024
Kogan

Kogan - Logo

USER GUIDE

SLIM TILT ADJUSTABLE WALL MOUNT
(37″ – 85″)
KAWLM85TSMA

SAFETY & WARNINGS


CAUTION:

Rated weight is 75kg (165 lbs).
Use with products heavier than the rated weights indicated may result in instability causing possible injury.

  • Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.

  • Safety gear and quality tools must be used.

  • This product is suitable for installation on solid concrete walls, masonry walls or wood stud walls.

  • Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.

  • Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.

  • Do not allow children to play near this stand.

  • This product contains small items that could be a choking hazard if swallowed.
    Keep these items away from children.

  • This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.

  • A minimum of two people are recommended for this installation. Failure to use safety gear and safe working methods may result in property damage, serious injury or death.

IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, contact your place of purchase for a replacement.

MAINTENANCE: Check that the product is secure and safe to use at regular intervals (at least every three months).

Suitable for TVs 37″ ­ 85″ maximum
VESA compatibility: 150×100 150×150 200×100 200×200 200×400 300×200 300×300 350×350 400×200 400×300 400×400 600×200 600×300 600×400

COMPONENTS

Wall mount assembly:
Kogan Slim Tilt Adjustable Wall Mount - Wall mount
assembly

Adapters (depends on TV):
Kogan Slim Tilt Adjustable Wall Mount - Adapters \(depends on
TV\)

ASSEMBLY

Additional Tools Required (Not Supplied):
Kogan Slim Tilt Adjustable Wall Mount - Additional Tools Required \(Not
Supplied\)

Step 1:

Kogan Slim Tilt Adjustable Wall Mount - Assembly Step
1
Step 2:
Drywall, plaster or timber walls (with studs)
Use a stud finder to locate safe and suitable locations to install into wall. Use a spirit level to double check the correct angle of the mount and mark the intended hole positions with a pencil. Drill holes in the desired locations (55mm deep, 4.5mm wide).
Kogan Slim Tilt Adjustable Wall Mount - Additional Tools Required \(Not
Supplied\) Step 2With the wall mount held in place, insert the washers and screws (W-C, W-A), tightening with a socket wrench. When installing on a drywall, plaster or timber wall, do not use the screw anchors (W-B).

Ensure washers and screws are aligned in the centre of opening. Do not install with washers and screws off to either side.

Step 2: Concrete and masonry walls
Use a spirit level to double check the correct angle of the mount and mark the intended hole positions with a pencil. Drill holes in the desired locations (60mm deep, 10mm wide).

Insert the screw anchors (W-B) into each pre-drilled hole. With the wall mount held in place, insert the washers and screws (W-C, W-A), tightening with a socket wrench.


Ensure washers and screws are aligned in the centre of opening. Do not install with washers and screws off to either side.

Step 3: Attaching the mounting brackets to your TV.
Depending on your TV, a combination of spacers (M-G, M-H) may be required to help create the correct amount of space for the brackets. Ensure the screws are fitted correctly into your TV’s VESA mount holes, and are not too long or too short in the back of the TV.
Step 4: Attaching the TV to the wall mount.
With two people, lift the TV up and above the installed wall mount and gently lower down into place, ensuring the TV is positioned evenly in the middle of the mount.

A minimum of two people are recommended for this installation. Failure to use safety gear and safe working methods may result in property damage, serious injury, or death.

ADJUSTING

Kogan Slim Tilt Adjustable Wall Mount - ADJUSTING Note: If the display does not stop at your desired position, tighten the screws as shown

REMOVING

This wall mount features automatic spring locks with quick release cords. To remove the TV from the mount, pull down on the quick release cords (1) to engage the spring locks and release from the mount (2). Ensure two people are supporting the TV during this process.

Kogan Slim Tilt Adjustable Wall Mount - REMOVING 1

NOTES
__

Need more information?
We hope that this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com

Kogan - Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals