ACURITE 06003RM 5-in-1 Sensor Pro Add-On Instruction Manual
- June 7, 2024
- Acurite
Table of Contents
5-in-1 Sensor Pro Add-On
model 06003RM/5N1DSSA
WHAT YOU NEED:
- 5-in-1 sensor
- Spray lubricant
- Phillips head screwdriver
The Pro Add-On with dual solar panels for the 5-in-1 sensor optimizes the
sensor’s sun exposure, allowing the sensor’s solar-powered aspirating fan to
run more often. The sensor’s internal fan helps to optimize the measurement of
the temperature throughout all hours of the day.
The AcuRite 5-in-1 sensor features a modular design that allows for the
replacement of certain parts. The electronic components inside the 5-in-1
sensor are sensitive – HANDLE WITH CARE.
NOTE: A 5-in-1 sensor is required to install the Pro Add-On.
TO LUBRICATE:
- Remove the screw located below the sensor’s wind cups. Keep the screw for step 4.
- Spray a small amount of lubricant into the hole.
- Tip the 5-in-1 Sensor upside down (so wind cups are on the bottom), then right side up several times.
- Reinsert the screw (removed during step 1) into the hole.
Prior to installation of the Pro Add-On, remove batteries from the 5-in-1
sensor to avoid erroneous data while handling and transporting the
sensor.
-
Remove 4 LONG screws and separate the upper white portion from the lower gray portion of the sensor.
-
Set aside the lower gray portion of the sensor and the screws for reassembly.
-
Remove 4 SHORT screws, located on the upper white portion of the sensor near the fan assembly. Keep the screws for reassembly.
-
Gently remove the upper wind speed / solar assembly from the rain gauge assembly and discard.
-
Line up the screw holes on the Pro Add-On with the rain gauge assembly.
-
Turn the upper white portion of the sensor over. Reinstall the 4 SHORT screws; tighten by hand.
-
Reinstall 4 LONG screws to connect the upper white portion and a lower gray portion of the 5-in-1 sensor. Installation is complete!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>