Kogan Solar Ultrasonic Possum & Pest Repeller User Guide
- June 7, 2024
- Kogan
Table of Contents
USER GUIDE
SOLAR ULTRASONIC
POSSUM & PEST REPELLER
PSULTPSTRPA
SAFETY & WARINGS
- Read instructions in this guide before using this product. Retain this guide for future reference.
- This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the product in a safe way by the person responsible for their safety, and understand the hazards involved.
- Do not install this product in any area where children and babies are playing.
Battery Safety
- Before first use. charge the battery using the supplied USB cable for two (2) full cycles. Each charging cycle should be approximately 8 hours.
- When the battery is low, the red-light low voltage indicator will begin flashing. Connect the device to a USB output (such as a computer or phone charger), using the USB cable included. The device will be fully charged in approximately 6 hours. After fully charging, the red indicator will become solid.
- Due to transportation, warehousing, and distribution, the time taken to recharge the battery may initially vary. This is normal. After charging the battery three times, the battery will stabilize its charging pattern and duration.
- Due to the geographical difference, the battery charging effect may be different. It’s recommended to charge the device at least once a month.
- If the rechargeable battery is new or the battery has been stored in the device without usage for more than o month, it is normal for the rechargeable battery to charge faster than usual.
- Please take out the batteries if you didn’t use the device for a long time. Otherwise, if the device is not used for a long duration, we recommend replacing the three 1.2V AA rechargeable batteries (replace with Ni-Cad or Ni
- M1-1). The better quality of the batteries and the larger capacity, the better the overall performance of the device.
- Please dispose of the batteries in accordance with your local environmental authority.
OVERVIEW
| 
---|---
INSTALLATION
Where to Place the Device
-
For best results, place the product in o location facing the direction of the unwanted animals.
-
Choose o location where the solar panel on the top of the unit can get as much sun as possible, avoiding obstacles that may block sunshine. If there is any dust or dirt on the solar panel, wipe clean to ensure the efficiency of the solar panel.
-
Attach the aluminum stand to the underside of the repeller. Plant the unit into the ground in the desired location.
Note: Do not use external force to hammer the top of the product Doing so may damage the solar panel. -
When selecting the location, ensure the inputs will not be exposed to water during poor weather conditions.
-
The rear of this product features a hole allowing you to mount the device above the ground.
OPERATION
This product uses a combination of strong ultrasonic signals and strobing lights which frighten and deter wild animals. The ultrasonic signal is activated when an animal enters the motion sensor’s range.
Adjusting the Settings
- “SENS” knob (Sensitivity): Turn the knob clockwise to increase the range of the motion sensor.
- “FRED’ knob (Frequency): Turn the knob clockwise to adjust the frequency of the ultrasonic signal
Ultrasonic Frequency Settings:
| 0 | Off |
|---|---|
| 1 | 13.5KHz-17.5KHz. Repels small rodents. |
| 2 | 15.5KHz -19,5KHz. Repels large dogs and foxes. |
| 3 | 19.5KHz -23.5KHz. Repels small dogs, cats, and birds. |
| 4 | LED flashing |
| 5 | Auto: All functions, cycle between 13.5-23.5KHz with LED flashing. |
Note: To change the frequency setting, you will first need to return the dial to the OFF position and then directly to the desired setting.
Ultrasonics Waves:
The ultrasonic emitter used in this product is very powerful. Some people can
hear part of its range. Therefore, it is recommended to place the product as
far as possible from people.
Do not install this product in any area where children and babies are playing.
SPECIFICATIONS
| Power supply | x3 1.2V AA rechargeable batteries (Ni-Cad or Ni-MH) |
|---|---|
| Motion sensor angle | 110° |
| Detection range | 8 – 9m (depending on animal size) |
| Waterproof | IPX4 |
Need more information?
We hope that this user guide has given you the assistance needed for a
simple setup.
For the most up-to-date guide for your product, as well as any additional
assistance you may require,
head online to help.kogansom
Kogan.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>