MAPerformance MAP INFQ-DPC Downpipes Instruction Manual
- June 3, 2024
- MAPerformance
Table of Contents
MAP INFQ-DPC
Install Instructions
What’s in the box?
2x Catted Downpipes
2x Lower Downpipe Gaskets
4x M10 Flange Nuts
4x M10 Flange Bolts
Tools needed
You will need:
14mm socket
14mm wrench
3/8” ratchet
3/8” extension
3/8” swivel socket
02 Sensor socket
Step 1
To remove OEM downpipes, follow these instructions in reverse order of this
installation guide
Step 2
Install 02 sensors into the downpipes with 02 sensor socket to avoid damaging
the sensor
Step 3
Attach MAP downpipes to the midpipes with included hardware, and leave the
connection loose until a later step
Step 4
Attach downpipes to OEM downpipe hanger brackets and leave the hardware
loose until a later step
Step 5
Push
the downpipe upwards until the vband on the MAP downpipe meets with the outlet
flange on the turbo
Step 6
Slip vband clamp over the MAP downpipe, we have found it to be easier with the
bolt removed from the downpipe
Step 7
Using an extension and a 14mm socket, reinstall the vband bolt and tighten, it
may be needed to pry the heat shield around the turbo open slightly to allow
room for hands and tools
Step 8
Tighten the midpipe connection and hanger connection
Step 9
Plug in 02 sensors IF installing on 2023+ Nissan Z you must unclip the
passenger side 02 sensor connector from its mount to allow for enough slack to
connect 02 sensor
Step 9.1
Plug in 02 sensors IF installing on 2023+ Nissan Z you must unclip the
passenger side 02 sensor connector from its mount to allow for enough slack to
connect 02 sensor
We hope you enjoy your purchase! Reach out to us with any issues or concerns.
1-888-627-3736
@maperformance
support@maperformance.com
www.facebook.com/modernautomotiveperformance/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>