nedis HTFA11CWT Ceramic Fan Heater User Manual

June 7, 2024
nedis

nedis HTFA11CWT Ceramic Fan Heater User Manual
nedis HTFA11CWT Ceramic Fan Heater

Thank you for purchasing our series of Fan Heaters. Each unit has been manufactured to ensure safety and reliability before the first use. Read the instructions carefully and keep them for future reference.

IMPORTANT SAFEGUARDS

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or a lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

When using any electrical appliance, basic precautions should be followed. Please read the following instructions as they are for your benefit and safety:

  1. Make sure the power supply used corresponds to the rating label.
  2. Never obstruct or block any opening of the heater.
  3. Use the heater only on a flat surface.
  4. Always disconnect the appliance from the main power supply when not in use or when cleaning.
  5. Do not leave the heater unattended when it is “ON”.
  6. WARNING: DO NOT COVER, means: In order to avoid overheating, do not cover the heater.
  7. Keep the appliance a distance of at least 90cm from any flammable material such as furniture, curtains, bedding, clothes or papers etc.
  8. Do not use the heater close to a bath, a shower or a swimming pool.
  9. Do not immerse the heater in water or allow water to come into contact with the plug or control device.
  10. Keep the heater clean. Do not allow objects to enter the ventilation opening as this may cause electric shock or fire, damaging to the heater.
  11. Close supervision is required when any appliance is used near or by children.
  12. Keep electrical appliances out of reach from children or infirm persons. Do not let them use the appliances without supervision.
  13. Do not use outdoors.
  14. Do not place on or near a lit gas or electric burner.
  15. If the power cord is damaged, it must be replaced by the manufacturer or its service agent, or a similarly qualified person must replace it in order to avoid a hazard.
  16. Do not use the appliance in places other than its intended use as described in these instructions.
  17. The heater must not be located immediately below a socket outlet.
  18. This appliance is intended for household use only.
  19. Do not leave the heater on overnight.
  20. When cleaning, make sure not to use a wet cloth or use water on any part of the unit, as this may cause a short circuit or electric shock.
  21. Do not use the unit in any area where water is present.
  22. Make sure the power is placed at the back away from the front panel of the heater.
  23. When moving the appliance, do not touch the outlet grilles.
  24.  When use the appliance, do not put the appliance on the floor.

STRUCTURE AND PARTS

Overview

  1. Switch (I=750W, II=1500W)
  2. Thermostat
  3. Oscillation Button
  4. Indicator light
  5. Outlet
  6. Base

HOW TO OPERATE

  1. Remove the unit from the box and take off any protective wrapping.
  2. Place the heater on a smooth level surface at least 30cm away from any obstacles.
  3. Plug your fan heater into the power supply. Make sure your power supply corresponds to the power indicated on the rating label.
  4. Turn the knob to “I” for the warm wind-low power 750W, then turn the knob to “II” for hot wind-maximum power 1500W.
  5. Turn the thermostat switch clockwise or anti-clockwise to set the desired temperature. The thermostat switch will keep the room temperature at the required level automatically.
    Note: Do not force the knob beyond its normal stop position.

OVERHEATING SAFETY DEVICE

Your heater is fitted with a safety device that switches off the heater in the event of overheating.
If the heater stops working, turn the heater off and inspect the blockage of the inlet or outlet. Wait at least 5 minutes for the protection system to reset before attempting to restart the heater.
If the safety device still switches the heater off and makes the heater failto operate, take the heater to your nearest service center for inspection or repair.

CLEANING YOUR FAN HEATER

  1. Always disconnect the appliance from the main supply before cleaning.
  2. Clean the outside of the heater by wiping with a damp or dry cloth.
  3. Do not use petroleum, or any other detergent or chemical solvent to clean the heater

Safety precautions:

Caution iconCaution:

Safety iconRisk of Electric Shock: Do not open

To reduce risk of electric shock, this product should ONLY be opened by an authorised technician when service is required. Disconnect the product from mains and other equipment if a problem should occur. Do not expose the product to water or moisture.

Maintenance:

Clean only with a dry cloth. Do not use cleaning solvents or abrasives.

Warranty

No guarantee or liability can be accepted for any changes  and modifications of the product or damage caused due to incorrect use of this product.

General:

  • Designs and specifications are subject to change without notice.
  • All logos, brands or brand logos and product names are trademarks or registered trademarks of their respective holders and are hereby recognised as such.
  • This manual was produced with care. However, no rights can be derived. König Electronic can not accept liability for any errors in this manual or their consequences.
  • Keep this manual and packaging for future reference.

Attention:

Dustbin icon This product is marked with this symbol. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collections system for these products.

This product has been manufactured and supplied in compliance with all relevant regulations and directives, valid for all member states of the European Union. It also complies with all applicable specifications and regulations in the country of sales.
Formal documentation is available upon request. This includes, but is not limited to: Declaration of Conformity (and product identity), Material Safety Data Sheet and product test report.

Please contact our customer service desk for support: via
website: http://www.nedis.com/en-us/contact/contact-form.htm
via   e-mail: service@nedis.com
via telephone: +31 (0)73-5991005 (during office hours)

NEDIS B.V, De Tweeling 28, 5215 MC’s-Hertogenbosch, THE NETHERLANDS

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals