APC USB Wi-Fi Device AP9834 User Guide
- June 7, 2024
- APC
Table of Contents
APC USB Wi-Fi Device AP9834
NOTE: A supported Network Management Card 3 (AP9641/AP9643) with valid TCP/IP settings running firmware version 1.4 or higher is required to use and configure the APC USB Wi-Fi Device.
Insert the APC USB Wi-Fi Device into an available USB port.
Enable and configure wi-fi via the NMC Web UI
(Configuration > Network > Wi-Fi navigation path), or Command Line Interface
(wifi command). For more information, consult the NMC 3 User Guide and CLI
Guide on the APC website – apc.com/upsnmc
NOTE: The APC USB Wi-Fi Device’s LED will flash green when wi-fi has
successfully been configured and connected to the wi-fi network.
For more information and troubleshooting, refer to the NMC 3 User Guide on the APC website – apc.com/us/en/download/document/SPD_CCON- AYCEFJ_EN
© 2020 Schneider Electric. All Rights Reserved. Schneider Electric and APC are trademarks and the property of Schneider Electric SE, its subsidiaries and affiliated companies.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>