VYNCO VMC334 Series Combined Meter Board Instruction Manual
- June 7, 2024
- VYNCO
Table of Contents
VYNCO VMC334 Series Combined Meter Board
SPECIFICATIONS
SPECIFICATIONS
Rated Operational Voltage| 415V AC maximum, 50Hz
Maximum Current| 100A
Rated Insulation Voltage| 1000V
Short Circuit Withstand| 10kA
DIMENSIONS
DIMENSIONS
Cover Assembly| 900 x 402 x 77mm
Base Box Dimensions| 853 x 355 x 150mm
Overall Assembled Dimensions| 900 x 402 x 171mm
Total Internal Meter Mounting Space| 310 x 320 x 139mm
Maximum Meter Depth| 130mm
WARRANTY
This product is covered by a 1 Year Vynco Warranty – proof of purchase is required. Please contact Vynco for details of returns procedure.
NOTE : This product contains NO user-serviceable parts.
SAFETY
- This product complies in full with AS/NZS 61439.3.
- This product should be installed by a suitably qualified person in accordance with Australian and New Zealand wiring rules.
INSTALLATION PROCEDURE
- This product is designed to be installed inside a wall cavity with a minimum stud size of 90mm and a minimum plaster board/wall covering of 10mm.
- The metal wall enclosure must be earthed. Fold out tags (x6) on the side walls of the enclosure can be folded out to set the correct height onto the studs.
- Door hinge pins are easily removable and the door can be reversed so that it swings either left or right. This product is designed to be used with
- New Zealand and Australia’s MEN system.
- DO NOT install a link between the neutral bars and earth bar on circuits dedicated to RCDs. Please ensure circuits and protective devices are adequately identified during installation.
EARTH AND NEUTRAL BUSBAR LAYOUT
EARTH AND NEUTRAL BUSBAR LAYOUT
| Material| Number of Bars| Double Screw Tunnels| Single
Screw Tunnels
Earth Bar| Brass with steel screws| 1| 3| 30
Neutral Bar| Brass with steel screws| 1| 4| 14
RCD Neutral Bar| Brass with steel screws| 5| 1| 3
REMOVING DOOR
-
STEP 1
Rotate top pin 90°. -
STEP 2
Slide pin down to release door. There is no need to remove pin completely. -
STEP 3
Lift and remove door.
FITTING DIAGRAM
To fit into wall cavity, fold out tabs to set the height of the enclosure onto
studs.
VYNCO INDUSTRIES (NZ) LIMITED CHRISTCHURCH
- 388 Tuam Street, Phillipstown, Christchurch, 8011 PO Box 9022, Tower Junction, Christchurch 8149 New Zealand
- P +64 3 379 9283
- E sales@vynco.co.nz
- VYNCO.CO.NZ
AUCKLAND
- 9 Levene Place, Mount Wellington
- PO Box 12 249, Penrose, Auckland 1061 New Zealand
- P +64 9 525 6051
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>