J08 Series Wireless Bluetooth Earbuds User Manual
- June 6, 2024
- Earbuds
Table of Contents
J08 Series Wireless Bluetooth Earbuds
+ +
YY +
8 8
61x54x31 42.5
8
After taking out the headphones, the left and right ears will automatically
form a team. Wait about 5 seconds for the automatic team to succeed. At this
time, the headphones will enter the state of waiting for mobile phone pairing
When pairing with the mobile phone for the first time, the mobile phone takes
out the headset in the Bluetooth state and waits for pairing. Search the
device “J08” in the mobile phone J tooth and connect it. After pairing is
successful, the binaural light flashes.
When you do not use the headset, you can put the headset back into the charging bin. If the red light on both ears is to charge the headset. When you use it again, just take out the headset to automatically form a team and automatically connect back to the last used mobile phone
Tap 1 to play pause / answer and hang up, touch 2 to increase volume in left ear / decrease volume in right ear, and touch 3 to switch song. Next song in left ear / last song in right ear, Touch 4 times in a row to switch sound effect. Long press for 3 seconds to wake up the voice assistant, long press for 2 seconds to reject the call.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures: — Reorient or relocate the receiving antenna. — Increase
the separation between the equipment and receiver. — Connect the equipment
into an outlet on a circuit different
from that to which the receiver is connected. — Consult the dealer or an
experienced radio/TV technician for help. The device has been evaluated to
meet general RF exposure requirement. The device can be u sed in portable
exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>