VYNCO VMC34 34 WAY COMBINED METER BOARD Instruction Manual

VYNCO VMC34 34 WAY COMBINED METER BOARD

SAFETY

This product complies in full with AS/NZS 61439.3. This product should be installed by a suitably qualified person in accordance with Australian and New Zealand wiring rules.

INSTALLATION PROCEDURE

• This product is designed to be installed inside a wall cavity with a minimum stud size of 90mm and a minimum plasterboard/ wall covering of 10mm.
• This product is designed to be installed inside a wall cavity on its own. For surface, mounting use VMCC surface mount enclosure in conjunction with this board.
• The metal wall enclosure must be earthed. Fold-out tags (x6) on the side walls of the enclosure can be folded out to set the correct height onto the studs.
• Door hinge pins are easily removable and the door can be reversed so that it swings either left or right. This product is designed to be used with New Zealand and Australia’s MEN system.
• DO NOT install a link between the neutral bars and earth bar on circuits dedicated to RCDs.
• Please ensure circuits and protective devices are adequately identified during installation.

SPECIFICATIONS

SPECIFICATIONS

Rated Operational Voltage| 415V AC maximum, 50Hz
Maximum Current| 100A
Rated Insulation Voltage| 1000V
Short Circuit Withstand| 10kA

DIMENSIONS

DIMENSIONS

Cover Assembly| 800 x 400 x 35mm
Base Box Dimensions| 754 x 355 x 98mm

WARRANTY

This product is covered by a 1 Year Vynco Warranty – proof of purchase is required. Please contact Vynco for details of returns procedure.
NOTE:
This product contains NO user-serviceable parts.

EARTH AND NEUTRAL BUSBAR LAYOUT

EARTH AND NEUTRAL BUSBAR LAYOUT

| Material| Number of Bars| Double Screw Tunnels| Single Screw Tunnels
Earth Bar| Brass with steel screws| 1| 3| 30
Neutral Bar| Brass with steel screws| 1| 4| 14
RCD Neutral Bar| Brass with steel screws| 5| 1| 3

REMOVING DOOR[](https://manuals.plus/wp-content/uploads/2022/07/VYNCO-

VMC34-34-WAY-COMBINED-METER-BOARD-fig-1.png)

1. STEP 1
   Rotate top pin 90°.

2. STEP 2
   Slide pin down to release door. There is no need to remove pin completely.

3. STEP 3
   Lift and remove door.

FITTING DIAGRAM[](https://manuals.plus/wp-content/uploads/2022/07/VYNCO-

VMC34-34-WAY-COMBINED-METER-BOARD-fig-2.png)

To fit into wall cavity, fold-out tabs to set height of enclosure onto studs.

VYNCO INDUSTRIES (NZ) LIMITED CHRISTCHURCH 388 Tuam Street, Phillipstown, Christchurch, 8011 PO Box 9022, Tower Junction, Christchurch 8149 New Zealand P +64 3 379 9283 F +64 3 379 6838  E [email protected] / VYNCO.CO.NZ

AUCKLAND
9 Levene Place, Mount Wellington PO Box 12 249, Penrose, Auckland 1061 New Zealand  P +64 9 525 6051 F +64 9 525 5799

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>