concept FR1200 Air Fryer User Manual

: June 6, 2024
: concept

Table of Contents

Acknowledgments
IMPORTANT SAFETY PRECAUTIONS
PRODUCT DESCRIPTION
CONTROL PANEL LAYOUT
BEFORE FIRST USE
PREPARATION FOR USE
OPERATING INSTRUCTIONS
ROTISSERIE
TIPS
PRE-SET PROGRAMS
CLEANING AND MAINTENANCE
SERVICE CENTRE
ENVIRONMENTAL CONCERNS
WARRANTY TERMS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Air fryer

concept FR1200 Air Fryer

Acknowledgments

Thank you for purchasing a Concept product. We wish you much joy with your new appliance every day you use it.
Please read the instruction manual carefully before initial use. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance.

Technical specifications

Caution!
Hot surface

IMPORTANT
Before connecting to the mains, make a visual check to ensure that the unit is intact and that no damage occurred during transport.

IMPORTANT SAFETY PRECAUTIONS

Do not use the appliance in any other way than as described in this manual.
Remove all the covering and marketing materials from the appliance before the first use.
Make sure the mains voltage corresponds to the values on the rating plate of the product.
Place the appliance on a stable, flat surface away from other heat sources.
When disconnecting the appliance from the wall outlet, never pull the power cord, grasp the plug end and disconnect it by removing it from
the receptacle.
Do not allow children or unauthorized people to handle the appliance, use it out of their reach.
Persons with reduced mobility, reduced sensory perception, mental disadvantage or persons not familiar with the operation must use the
appliance only under the supervision of a responsible person, who is familiar with the instructions.
Pay extra attention if the appliance is used near children.
Do not use the appliance as a toy.
Never put your fingers, pencils, or other objects through the air outlet grille.
Do not cover the appliance.
Before assembly and disassembly, disconnect the power cord from the wall outlet.
Before cleaning and after use of the appliance, switch the appliance off and disconnect it from the mains.
Keep the appliance clean, do not allow foreign objects to into the grid openings. It could cause serious injury, short circuit, damage to the
appliance, or cause fire.
Do not use the appliance with a damaged cord or plug and have it repaired immediately by an authorized service center.
Do not use the appliance if it is not working properly, has been dropped, damaged, or immersed in liquid. Have it checked and repaired by an
authorized service center.
The appliance is only suitable for home use and is not intended for commercial use.
Do not touch the appliance with wet hands.
Do not immerse the power cord, plug, or appliance in water or any other liquid.
Do not repair the appliance yourself. Contact an authorized service center.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Cleaning and maintenance performed by the user must not be carried out by children unless they are 8 years old and under supervision. Children aged under 8 years of age must be kept away from the appliance and its power cord. Do not let children play with the appliance.
Do not touch hot surfaces
Do not let the power cord hang freely over the edge of a table or kitchen unit. Do not let the power cord touch hot surfaces.
Do not place the appliance near a gas or electric burner.
CAUTION: The surfaces of the appliance may be very hot. Hold the appliance by the handle only and wear protective equipment such as a kitchen glove.
Pay special attention to prevent water or other liquid from entering the appliance. This could cause an electric shock.
Always place the ingredients in the appliance basket to prevent them from coming into contact with the heater.
Never touch the inner surfaces of the appliance during operation or immediately after switching off. Allow the appliance to cool down sufficiently.
Do not plug in or operate the appliance with wet hands.
During frying with hot air, hot steam is released through the air outlets, keep your hands and face at a safe distance from the water vapor coming from the air outlets.
If you see dark smoke coming out of the appliance during operation, switch it off immediately and contact an authorized service center.
Before cleaning the appliance allow it to cool down for at least 30 minutes.

Damages from failure to follow the manufacturer’s instructions are not covered by the warranty.

PRODUCT DESCRIPTION

concept FR1200 Air Fryer -FIG 1

1. Upper cover
2. Display
3. Side cover
4. Appliance body
5. Power cord
6. The interior
7. Door| 8. Handling pliers
9. Rotisserie fork
10. Grid
11. Basket
12. Drip tray
13. Baking tray
---|---

CONTROL PANEL LAYOUT

A. n On/Off switch
B. Program selection
C. Buttons for setting the temperature
D. Buttons for setting the time
E. Increasing temperature/time +| F. Decreasing temperature/time
G. Set program
H. Rotation for chicken program
I. Light
---|---

concept FR1200 Air Fryer -FIG 2

BEFORE FIRST USE

Remove all packaging materials from the appliance.
Remove all labels and stickers from the appliance.
The appliance accessories: handling pliers (8), rotisserie fork (9), grid (10), basket (11), drip tray (12) and baking tray (13) should be washed with hot water and detergent. All accessories of this appliance are dishwasher safe.
Wipe the appliance thoroughly from the inside and outside with a cloth.
Warning: This fryer operates using hot air. Never use oil or other frying liquids.

PREPARATION FOR USE

Place the appliance on a flat and stable surface (do not place the appliance on a flammable surface).

OPERATING INSTRUCTIONS

Place the appliance in a dry, level place.
Plug the power cord into a power outlet. You will hear a sound signal, all the indicators will flash briefly and the switch button (A) lights up.
Open the door of the appliance (7) and place the drip tray (12) on the bottom of the appliance.
Use the accessories depending on the selected program. Place the food in the appliance and carefully close the appliance door.
To switch on the appliance, press the On/Off button (A).
Use the program selection button (B) to set the desired program (G). According to the set program, the display shows the pre-set time and temperature.
Briefly press the On/Off button (A) to confirm the program. The appliance will start working.
Note: Press the temperature selection button (C) or time selection button (D) and then press the “+” (E) or “-” (F)
buttons to change the pre-set frying time or temperature.
At the end of the program, you will hear a beep.
To switch the appliance off, press the On/Off button (A).
Check if the food is ready. Remove the accessories with ready-to-eat food and place them on a heat-resistant surface.
Note: The appliance surfaces are hot. Always use kitchen gloves when manipulating with appliance accessories!

ROTISSERIE

Skewer the chicken you prepared (of max 1.2 kg) on the rotisserie axis and secure the tips on both sides. Secure all parts of the chicken with kitchen twine.
Place the rotisserie fork with the chicken prepared in this way in the holes in the sides of the appliance.
Use the program selection button (B) to select the chicken program, press the rotation button (H) and switch on the program with the switch (A).
As the program starts, the rotisserie begins to rotate slowly 360° to achieve perfectly even baking.
Use the handling pliers (8) to remove the baked chicken rotisserie from the appliance.

concept FR1200 Air Fryer -FIG 3

TIPS

The larger the chicken or the amount of food you prepare, the longer the roasting/cooking time. Adjust the temperature and cooking time according to your needs.
You can open the appliance door and check the food at any time during cooking. After closing the door, the program will automatically continue.
When using the appliance for baking, it is necessary to use a baking form.
You can easily check the condition of the food without opening the appliance by pressing the light (I) button.

PRE-SET PROGRAMS

Pro
gram| Temperature (°C)| Time (min.)
---|---|---

Fries

|

220

|

25

Ice out

|

80

|

10

Wings

| 200|

15

Dehydrate

|

70

|

8 hrs.

Steak

|

180

|

12

Chips

|

220

|

20

Fish

|

180

|

15

Vegetables

|

180

|

12

Popcorn

|

220

| 10 (+ 2 min for pre- heating)

Chicken

|

220

|

40

Cake

|

180

|

30

Manual

|

200

|

15

Pizza

|

180

|

15

Keep Warm

|

80

|

30

Toast

| 200|

4

Cookie

| 180|

12

CLEANING AND MAINTENANCE

Clean the appliance after each use.
Do not use coarse and chemically aggressive substances such as sharp objects, scrapers, chemical solvents, thinners, etc.

Before cleaning always disconnect the appliance from the mains. Never immerse the appliance or heater in water or any other liquid!
Before cleaning the appliance allow it to cool down.
Wipe the outside of the appliance with a damp cloth.
You can wash all accessories in water with detergent or in the dishwasher.

SERVICE CENTRE

Extensive maintenance or repair, which requires access to internal parts of the product, has to be performed by a qualified specialist or the service center.

ENVIRONMENTAL CONCERNS

Packaging materials and old appliances should be recycled.
Packaging materials may be disposed of as assorted waste.
Dispose of the plastic bags made of polyethylene (PE) of assorted waste.

Recycling of the appliance at the end of its lifespan:

This appliance is labeled in accordance with European Directive 2012/19/EU concerning used electrical and electronic appliances (Waste Electrical and Electronic Equipment – WEEE). The symbol on the product or on its packaging indicates that this product may not be treated as household
waste. Instead, it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The disposal of such material has to be done according to the recycling regulations. For more detailed information about the recycling of this product, please contact your local council, your household waste disposal service, or the shop where you purchased the appliance.

The product meets all the necessary requirements of the EU directives applicable to the specific product.
Changes in text, design and technical specifications are subject to change without prior notice and we reserve the right to change them.

WARRANTY TERMS

Warranty

The manufacturer (or importer) is responsible for ensuring the product complies with the requirements of applicable legal regulations as well as those of the relevant technical standards. Moreover, they are responsible for ensuring the product has the properties the manufacturer described in documents related to the goods or those reasonably expected by the customer with regard to the nature of the goods or based on advertising produced by the manufacturer, and further, they are responsible for ensuring the product is fit for the purpose proposed by the manufacturer or that
a product of the same type is normally used for.
The quality warranty term is 24 months from product takeover by the customer. The warranty does not apply to wear and tear caused by regular use. The customer shall not be entitled to any warranty claims if, prior to taking the product over, they knew the product contained a defect or if the defect is attributable to the customer.
The warranty specifically does not apply:

if the product installation, operation, and service conditions stipulated in the product operating manual have not been adhered to,
to malfunctions caused due to mechanical, heat, or chemical damage, short circuit, over-voltage or incorrect installation,
to malfunctions caused by an inexpert third-party intervention,
to malfunctions caused by natural disasters,
to malfunctions caused by insufficient or inappropriate maintenance in violation of the operating manual, including malfunctions caused by water and other sediments,
to changes in color of the heating surface or to scratching of the surface caused as a result of using the products in an unusual manner, to appearance and functional changes caused by exposure to sunlight, thermal radiation of water and other sediments,
if the service life of certain product parts expires, e.g. for accumulators, bulbs, etc.

The warranty does not apply to any products and services provided along with the product (gifts,promotional articles, etc.).
Filing a complaint
A complaint against a product defect must be filed as soon as identified, yet no later than before the end of the warranty term.
The customer must file a product complaint with the dealer from which they have purchased the product, or with any authorised service centre, a list of which is included in the product package, or available at www.my- concept.com.
While filing a product complaint, the product must be duly cleaned and securely packed so as to prevent any damage during its transport to an authorised service centre, where relevant, unless the product is delivered in person.
The customer must submit proof of having concluded a purchase contract for the product by producing the receipt.
While filing their complaint, the customer must indicate the noted defect and identify the preferred complaint application method.
Complaints processing
As long as the noted defect may be removed, the user has the right to have the defect duly removed free of charge on a timely basis.
Where such a procedure is not reasonable with regard to the nature of the defect, the user may require to be supplied a new defect-free product (replacement), or, where the defect applies to a part of the product only, replacement of the part concerned. However, if replacement of the product or any part thereof is not proportionate with regard to the nature of the defect, especially if the defect can be removed without undue delay, the customer has the right to have the defect removed free of charge.

If the noted defect is not removable, or if the customer becomes entitled to the replacement of the product or a part thereof, yet the replacement is not possible, for example, due to the product having been sold out, the customer has the right to return the product (withdrawal from the contract).
The customer shall have the right to a new product (replacement) or to replacement of a part of the product even if the defect can be removed, provided they cannot properly use the product due to repeated occurrence of the defect or due to a high number of such defects. In such a case, the customer also has the right to return the product (by withdrawing from the contract).
If the product is not returned (the customer does not withdraw from the contract), or if the customer does not apply the right to a new defect-free product (replacement), to replacement of a part thereof, or to repair the product, they may request a reasonable discount. The customer also has a right to a reasonable discount if a new defect-free product cannot be supplied to them, or if a product part cannot be replaced or the product repaired unless the situation is remedied within a reasonable time limit, or if remedying the situation would create major discomfort on the part of
the customer.
The seller authorized service center or a staff member authorized by them must decide about each complaint immediately or within three business days in complicated cases. This term does not include a reasonable period of time, depending on the type of product concerned, required for the defect to be assessed by an expert.
A complaint, including defect removal, must be dealt with without any undue delay, yet no later than within 30 calendar days of the complaint filing date, unless the seller and the customer agree on a later deadline.
On returning the product (withdrawing from the contract) the customer must return any accessories and documents supplied along with the product.
The customer does not have the right to keep the defective parts and components of the product replaced as part of a repair of the product.
This shall be without prejudice to any other rights the customer may have in relation to the purchase of the product.
Remark : Complaints against products damaged in transport are governed by the carrier’s complaints procedure.

Manufacturer

Jindřich Valenta – Concept
Vysokomýtská 1800, 565 01 Choceň
Czech Republic
tel.: +420 465 471 400
fax +420 465 473 304
Company ID No. 13216660
email: servis@my-concept.cz
www: www.my-concept.com

Product data