Forney mpn4737425011 Fc-i Flux-Cored Welder User Guide
- June 6, 2024
- Forney
Table of Contents
EASY WELD™
CAT# 261
QUICK START GUIDE
140 FC-i FLUX-CORED WELDER
(DESIGNED FOR MILD STEEL WELDING ONLY)
- Read the user manual
- Install wire spool
0.030″ (0.8mm) diameter
8″ (200mm) wire spool
| 4″ (100mm) wire spool
---|---
3. Set drive roll
Face the side marked 0.030″ away from the machine
-
Feed wire and set pressure
For proper tension align the tops of the screw and nut together
-
Connect to Input Power
• Generator OK with continuous output > 4,000 W
• Extension cord: #12 AWG or larger; 25′ (8m) or shorter -
Remove consumables and depress trigger until wire comes out. Replace consumables.
-
Adjust wire feed speed ( ) and voltage ( )
See chart on welder for correct settings -
With contact tip 1/4″ from metal, depress trigger completely to initiate the arc
FIND FLUX-CORED WELDING TIPS AT WWW.ASKFORNEY.COM
QUESTIONS OR TROUBLE? Contact Forney Industries at
1-800-521-6038
customerservice@forneyind.com
askforney.com
forneyind.com
References
- AskForney | Have Questions? Find Answers Here at AskForney
- Forney Industries | Metalworking Resources
- AskForney | Have Questions? Find Answers Here at AskForney
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>