Forney 555 Air Compressors User Guide
- June 4, 2024
- Forney
Table of Contents
Forney 555 Air Compressors
Put On Appropriate Safety Equipment
Put on appropriate safety equipment. ALWAYS use the following safety equipment when operating your air compressor:
- Hearing protection is in accordance with ANSI Sl 2.6 (S3.19).
- Eye protection that is in accordance with ANSI 287.1.
Connect to Input Power
2.5 CFM and 4.5 CFM models: 110-120V ( 15A recommended) grounded wall outlet on independent circuit leg.
Ensure Tank Drain Valve is Closed
- The valve is located on the bottom of the compressed air tank.
- Close the valve by rotating the valve head clockwise until tight.
- Do NOT over-tighten!
Turn on Compressor Motor
- Rotate the power switch from “OFF” to “AUTO.”
- The compressor motor will start to fill the tank automatically. The compressor motor will automatically shut off when the tank is full (approx. 120 PSI Max).
Connect Air Hoses
Adjust Output Air Pressure
- The left gauge on the control panel displays the output air pressure in pounds-per-square-inch (PSI). The right gauge on the control panel displays the available pressure inside the compressed air tank.
- Turning the central knob clockwise will INCREASE the output air pressure. Turning the central knob counterclockwise will DECREASE the output air pressure.
- Turn Off Air Compressor when Finished
- Unplug From Input Power
Drain Air Tank
- Turn off and unplug the air compressor from the power source.
- Gently rotate the tank valve head counterclockwise until it starts to hiss.
- WARNING! Do not over-loosen the valve head!
20 P PLASMA CUTTER & MOUNTING BRACKETS ITEM# 251
The Forney Easy Weld 20 P Plasma Cutter is the perfect tool for the DIV
enthusiast. Weighing in at just over 20 lbs., the Forney Easy Weld 20 Plugs
right into a standard 120V wall outlet and slices through ¼” steel with ease.
Your new air compressor ( 4.S CFM unh only) was specifically designed to be an
all-in-one plasma culling station. Optional bracke15 can be purchased that
allows you to mount your Forney Easy Weld 20 P Plasma Cutter right on top of
the compressor creating the ultimate tool for less demanding plasma culling
jobs.
40 P PLASMA CUTTER & MOUNTING BRACKETS ITEM# 440
The Forney 40 P Plasma Cutter is powerful and able to clean cut W and sever up
lo¾’ solid steel. Your new air compressor (4.S CFM unh only) was specifically
designed lo be an all-in-one plasma cutting station and optimized to run the
Forney 40 P Plasma Cutter. Optional bracket5 can be purchased that allows you
to mount your Forney 40 P Plasma Cutter right on top of the compressor
creating the ultimate tool for mare demanding plasma cutting jobs.
FIND MORE INFORMATION AT FORNEYIND.COM
QUESTIONS OR TROUBLE? Contact Forney Industries at 1 ·800·521 ·6038,
customerservice@forneyind.com or visit
forneyind.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>