Forney 323 190 MP Welder User Guide
- June 9, 2024
- Forney
Table of Contents
Forney 323 190 MP Welder User Guide
Manual MIG
FIND MORE INFORMATION AT FORNEYIND.COM
TruSet™ MIG
- Select process according to diameter of wire being used (TruSet MIG .024”, .030”, or .035”).
- Follow steps 3-9 of Manual MIG setup.
- Push the right knob to light up the Wire/Gas LED then turn the knob to select the wire and shielding gas combination being used.
- Push the right knob again to light up the LED then turn the knob to select the workpiece thickness.
- The machine will set optimal voltage and WFS. Continue with step 11 of the Manual MIG setup.
- The automatic settings can be trimmed up or down with the left knob if you want to refine the weld settings.
Expert-Tech Tips:
- Best performance is at a trim setting between -5 and +5.
- Step up to the next material thickness to get more penetration.
MIG TROUBLESHOOTING TIPS
Low weld output or poor fusion
- Usually due to low input power.
- Welder should be only thing plugged into circuit.
- Avoid using extension cords. If one must be used, it must be 3 conductor #12 AWG or larger up to 25 feet.
- Generators must be a minimum 4,000W (120V) or 10,500W (240V) continuous output with no low-idle function (or low-idle off), 5% THD Max.
TIG QUICK START GUIDE
190 MP WELDER (NOT RECOMMENDED FOR ALUMINUM)
TIG TROUBLESHOOTING TIPS
QUESTIONS OR TROUBLE? Contact Forney Industries at
1-800-521-6038
customerservice@forneyind.com
forneyind.com
FIND MORE INFORMATION AT FORNEYIND.COM
STICK TROUBLESHOOTING TIPS
QUESTIONS OR TROUBLE? Contact Forney Industries at
1-800-521-6038
customerservice@forneyind.com
forneyind.com
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>