Forney Mounting Bracket Air Compressor Instruction Manual
- June 4, 2024
- Forney
Table of Contents
MOUNTING BRACKET INSTALLATION INSTRUCTIONS
Forney 4.5CFM Air Compressor (ITEM# 555)
& Forney 40 P Plasma Cutter (ITEM# 440)
PARTS LIST
Extra hardware is included for your convenience.
PREPARING YOUR FORNEY 4.5CFM AIR COMPRESSOR
Step 1- Locate the threaded holes on the side of the plasma cutter mounting rack.
Step 2- Using the provided hardware: Screws (x4), lock-washers (x4), and washers (x4), install the plasma cutter mounting brackets on each side of the compressor.
Helpful Tip: To make the final step of the installation easier, do not
tighten the screws all the way down until the plasma cutter is mounted onto
the compressor.
Instructions continued on back
MOUNTING YOUR FORNEY 40 P PLASMA CUTTER
Step 1- Locate the mounting holes on the legs of the Forney 40 P Plasma
Cutter. Align these holes with the upper mounting holes on the plasma cutter
mounting brackets.
Step 2 – Using the provided hardware: Screws (x4), lock-washers (x4), washers (x8), nuts (x4), bolt the Forney 40 P Plasma Cutter to the mounting brackets.
FOR MORE INFORMATION, VISIT FORNEYIND.COM
ORDER
Online: www.forneyind.com
Phone: 1-800-521-6038
Fax: 1-970-498-9505 SUPPORT
askforney.com
FL-2998
References
- AskForney | Have Questions? Find Answers Here at AskForney
- Forney Industries | Metalworking Resources
- Forney Industries | Metalworking Resources
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>