Kogan USB Condenser Microphone User Guide
- June 6, 2024
- Kogan
Table of Contents
USB CONDENSER
MICROPHONE WITH POP FILTER & STAND KACONMICPHA
**SAFETY & WARNINGS
**
- Lower the volume before moving the microphone as loud feedback can occur when the top of the microphone is covered by and or the microphone is moved near to the speaker.
- Take care not to let the microphone fall or suffer physical damage.
- Do not store the microphone in a hot or damp environment.
COMPONENTS
A Shock-proof stand
F Microphone holder
B USB sound card
G Condenser microphone
C Pop filter| H Vibration control frame
D Sponge ball
I Base
E Audio line
---|---
INSTALLATION
- Connect the base to the shock-proof stand.
- Hand-loosen the base using the dial on the back to adjust its clearance, then slide it over the installation surface and tighten it to secure. Use the small screw on the bottom to tighten further.
- Connect the top of the bracket to the plastic shock-proof frame.
- Use the large screw button of the bracket to adjust the bracket angle and use the small screw button on the frame to adjust the frame angle.
- Install the pop filter and sponge ball as shown below. Connect the audio cable and route it through the shock-proof stand
- After the microphone is installed and connected, connect the microphone to your computer using the audio cables (USB audio card & audio line).
OPERATION
Positioning your microphone:
This microphone is unidirectional. It is important to position the microphone
directly in line with the person speaking or instrument (or another sound
source) to achieve the best frequency response of the microphone.
The distance from the mouth should be approximately 10 – 40mm for optimal
recording. For speaking/singing applications, ensure the diaphragm (small
circular piece inside the grille) is facing the user.
SPECIFICATIONS
Polar pattern
Frequency response
Sensitivity
Output impedance
Load impedance
Equivalent noise level
Maximum SPL
S/N Ratio
Electrical current| Unidirectional
20Hz-20kHz
-34dB±2dB (0dB=1V/Pa at 1kHz)
150Ω±30% (at 1kHz)
≥1000Ω
16dBA
130dB (at 1kHz ≤ 1% T.H.D)
78dB
3mA
---|---
Need more information?
We hope that this user guide has given you the assistance needed for a simple
setup.
For the most up-to-date guide for your product, as well as any additional
assistance you may require, head online to
help.kogan.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>