kogan KACONMICPHB USB Condenser Microphone User Guide

June 6, 2024
Kogan

kogan KACONMICPHB USB Condenser Microphone User Guide
kogan KACONMICPHB USB Condenser Microphone

SAFETY & WARNINGS

  • Lower the volume before moving the microphone as loud feedback can occur when the top of the microphone is covered by hands or the microphone is moved near to the speaker.
  • Take care not to let the microphone fall or suffer physical damage.
  • Do not store the microphone in a hot or damp environment.

COMPONENTS

Component

  • A Shock-proof stand
  • B USB audio line
  • C Pop filter
  • D Sponge ball H Base
  • E Microphone holder
  • F Condenser microphone
  • G Vibration control frame

INSTALLATION

  1. Connect the base to the shock-proof stand.

  2. Hand-loosen the base using the dial on the back to adjust its clearance, then slide it over the installation surface and tighten it to secure. Use the small screw on the bottom to tighten further.
    Installation Instruction

  3. Connect the top of the bracket to the plastic shock-proof frame.

  4. Use the large screw button of the bracket to adjust the bracket angle and use the small screw button on the frame to adjust the frame angle.
    Installation Instruction

  5. Install the pop filter and sponge ball as shown below. Connect the audio cable and route it through the shock-proof stand.

  6. After the microphone is installed and connected, plug the audio cable to the compute
    Installation Instruction

OPERATION

Positioning your microphone:

This microphone is unidirectional. It is important to position the microphone directly in line with the person speaking or instrument (or other sound source) to achieve the best frequency response of the microphone.
Positioning your microphone:

The distance from the mouth should be approximately 10 – 40mm for optimal recording. For speaking/singing applications, ensure the diaphragm (small circular piece inside the grille) is facing the user.

SPECIFICATIONS

  • Polar pattern: Unidirectional
  • Frequency response: 20Hz-20kHz
  • Sensitivity: -34dB±2dB (0dB=1V/Pa at 1kHz)
  • Output impedance: 150Ω±30% (at 1kHz)
  • Load impedance: ≥1000Ω
  • Equivalent noise level: 16dBA
  • Maximum SPL: 130dB (at 1kHz ≤ 1% T.H.D)
  • S/N Ratio: 78dB
  • Electrical current: 3mA

Need more information?

We hope that this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals