next level RACING F-GT Elite Keyboard and Mouse Tray Instruction Manual
- June 6, 2024
- next level RACING
Table of Contents
next level RACING F-GT Elite Keyboard and Mouse Tray Instruction Manual
SIM RACING JOURNEY STARTS HERE
We know you’re eager to start racing! Take your time with the instructions and
follow this guide to assemble your product.
You’ll be setting yourself up for success with following the instruction
booklet to fully optimize your product.
PRE-RACE CHECKS
WARNING
- Please do not use power tools for assembly as over tightening can damage your frame
- Please ensure T-Nuts are correctly placed within the extrusion
- Do not force parts together
- Avoid cross threading bolts
- If in doubt consult the installation video or contact us on support@nextlevelracing.com
- Beware of sharp edges on the extrusion pieces
If you require any support with your product please contact our friendly team at: support@nextlevelracing.com
IN THE BOX
01 Install 2 x T-nut into the vertical post as shown. (Red dots for T-Nut
placement)
02 Bolt through the mounting bracket into the T-nuts previously installed in step 01.
03bLine up holes on the connector bracket with holes on the mounting
bracket previously installed in
Step 02 and install a barrel spacer between them.
03b Bolt through the lined up holes and secure with a nut.
04 Line up pre-drilled holes on the 40×40 extrusion with the holes on
the bracket previously installed in
step 03B, bolt through and secure with a nut.
05 Slide 2 x T-nut into the bottom channel of the extrusion
_ 06 Line the holes on the connector bracket with the pre-drilled holes in
the 40×40 extrusion then bolt through the bracket and holes with 2x M8 65mm
bolts, washers and the nuts.
_
07 Line up holes on the Keyboard connector bracket with the holes on the
connector bracket previously installed in
Step 06 and install a barrel spacer between the holes. Bolt through the
lined up holes and secure with a nut
08 Line up the Keyboard tray with the connecting bracket from Step 07
then install M8 barrel spacer between
the holes. Bolt through the brackets and spacer securing with an M8
nut.
09 Bolt through the Mouse Tray into T-Nuts previously installed in Step 05.
ASSISTANCE
If you require further support with your product please contact our friendly team at: support@nextlevelracing.com
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>