delta cycle HL6002 Smartphone Holder Instruction Manual

HL6002 Smartphone Holder

Assembly video
Visit designbydelta.com/downloads Smartphone Holder
Assembly instructions HL6002/HL6500

Parts

Tool Required
Phillips Head Screwdriver WARNING
Using phone device while riding can cause accidents resulting in serious injury.
Important: Nuts and bolts can loosen over time, resulting in serious danger should the item fall off while in motion.
Check frequently to ensure all bolts are properly tightened. Ensure the device fits snugly in the holder before riding.
Not for off-road use.

Using the Stem Mount

1. Remove existing stem cap from bicycle. Use existing stem bolt to install Smartphone Holder stem mount on to your bicycle stem. Open slightly in order to allow easy access to insert the bolt. Insert the bolt on the same side as the locking mechanism. (FIGURE 1)
2. Connect phone holder to stem mount using short bolt and adjust angle before full tightening. If necessary use the adhesive foam inserts to provide a snug fit for your device. (FIGURE 2)

Using the Handlebar Clamp

1. Connect phone holder to handlebar clamp using short bolt and adjust angle before full tightening. Open slightly in order to allow easy access to insert the bolt. Insert the bolt on the same side as the locking mechanism. (FIGURE 1)
2. Connect handlebar clamp to bar using rubber shims as needed. Use thumb screw; tighten to secure the handlebar clamp. If necessary use the adhesive foam inserts to provide a snug fit for your device. (FIGURE 2)

IMPORTANT SAFETY NOTE
Do not attach clamp to any tapered section of your handlebar.

Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
Service: Please do not return to store; for immediate response email service@designbydelta.com ****

References

• Video & PDF Instructions – Delta Cycle
• Delta – Delta Cycle

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>