COOPER Caretaker SR Refractor Installation Guide
- June 6, 2024
- Cooper
Table of Contents
COOPER Caretaker SR Refractor Installation Guide
Installation instructions – Caretaker SR Refractor
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this product must be performed by a qualified electrician. This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting any maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Refer to product label for specific minimum supply conductor requirements. Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
Risk of Personal Injury- Fixture may become damaged and/or unstable if not installed properly. Failure to comply with these instructions may result in death, serious bodily injury and property damage.
DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability
for damages or losses of any kind that may arise from the improper, careless,
or negligent installation, handling or use of this product.
NOTICE: Green ground wire provided in proper location. Do not relocate.
ATTENTION Receiving Department: Note actual fixture description of any
shortage or noticeable damage on delivery receipt. File claim for common
carrier (LTL) directly with carrier. Claims for concealed damage must be filed
within 15 days of delivery. All damaged material, complete with original
packing must be retained.
Safety: This fixture must be wired in accordance with the National
Electrical Code and applicable local codes and ordinances. Proper grounding is
required to insure personal safety. Carefully observe grounding procedure
under installation section.
APPLICATIONS: This lighting fixture is designed for outdoor lighting
services, and should not be used in area of limited ventilation or inside high
ambient temperature enclosures. It must be stored in a dry location prior to
installation. Do not expose lighting fixture to rain, dust or other
environmental conditions prior to installation and insertion of photo control
or shorting cap (if so equipped). Best results will be obtained if installed
and maintained according to the following recommendations
Installation instructions – Caretaker SR Refractor
Tools Required: 1/4” socket or flat head screwdriver.
Note: Fixture sold separately
Installation
-
Insert provided 8-32 x 1/2” thread forming screws into mounting holes. Place 1/8” O-rings over screw threads to hold screws within refractor. (Figure 1.)
-
Center refractor to luminaire housing and align refractor thru-holes to die-cast housing mounting holes. (Figure 2.)
-
Tighten the two screws into holes provided in die-cast housing approximately 7-10 in-lbs.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>