MAYTAG Square Shaped Reverse Door Swing Instructions
- July 31, 2024
- Maytag
Table of Contents
REVERSE DOOR SWING INSTRUCTIONS
REVERSE DOOR SWING: SQUARE-SHAPED DOOR
Square Shaped Reverse Door Swing
-
Remove door from dryer Using a T25®† screwdriver, remove the four screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Retain or set aside the four screws.
-
Move the door strike Using a T25® screwdriver, remove the two screws securing the door strike to the door frame of the dryer. Remove the four screws above and below the door strike and set aside for later use. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown.
-
Remove inner door from outer door Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 13 screws securing the inner door to the outer door. Lift off the inner door and set aside.
NOTE: There is a small release tab on each side of the door. If the inner and outer door do not separate easily, slide a credit card, putty knife, or similar flat object between the inner and outer doors at the locations shown to release the tab. -
Remove hinge and latch from inner door Using a T25® screwdriver, remove the three screws securing the latch plate and the five screws holding the hinge assembly in place.
-
Reinstall hinge and latch on opposite sides Using a T25® screwdriver, reinstall the latch plate and hinge assembly on the opposite sides from which they were removed.
-
Reattach inner door to outer door Position the inner door on the outer door assembly. Using a Phillips screwdriver, secure with the 13 screws removed earlier.
-
Reattach door to dryer Using a T25® screwdriver, reinstall the four screws securing the door hinge to the dryer.
W11685585A
©2024 All rights reserved.
Used under license in Canada.