Kogan MX11 Pro Cordless 29.6V Stick Vacuum Cleaner User Guide
- June 6, 2024
- Kogan
Table of Contents
MX11 PRO CORDLESS 29.6V
STICK VACUUM CLEANER
KAVACSTM11X
USER GUIDE
SAFETY & WARNINGS
- Ensure to read the instructions in this user guide thoroughly. Store the user guide for future use.
- Use the appliance on a stable, flat, heat-resistant surface.
- Never immerse any part of the plug or the main unit in water or other liquids.
- Never leave the appliance unattended while in use.
- Ensure the power supply voltage is as per the rated voltage.
- Remove the battery pack when not in use or for maintenance.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance in a safe way by the person responsible for their safety, and understand the hazards involved.
- This appliance is suitable for children 8 years and older. Pay close attention to children’s safety when they are near the appliance. Do not let children play with the appliance to avoid accidents.
- Do no let the pets go near the appliance.
- This appliance is for domestic use only. It should not be used for any purpose other than its intended use.
- Do not use this appliance to suck liquid, sharp objects such as nails, pushpins, etc.
- Do not disassemble or repair this appliance. Contact Kogan.com or the Kogan.com recommended professionals to repair the appliance.
- If the power cord is damaged, cease use immediately and contact Kogan.com
- Use this appliance with the Kogan.com recommended accessories.
- In the event of a malfunction, cease use immediately and contact Kogan.com
COMPONENTS
OVERVIEW
1 Primary Screen
2 Compact Screen
3 Dust Cup Lock
4 Dust Cup
5 Dust Release Button
6 Tube Lock
7 Aluminium Tube| 8 Brush Lock
9 Electric Brush
10 Charging Indicator
11 Battery Pack Lock
12 Battery Pack
13 On/Off Switch
---|---
Primary Screen
| Battery Level Indicator
---|---
| Brush Blockage Indicator
| Air-Duct Blockage Indicator
| Dust Sensor Failure Indicator
| Eco Speed
| High Speed
| Automatic Mode
ASSEMBLY
-
Choose an accessory according to your cleaning requirement.
-
Insert the aluminium tube into the main unit until it clicks into the place.
-
Insert the accessory you have chosen into the aluminium tube.
-
Make sure the installation is firm before you use it.
-
To remove the aluminium tube, press and hold the tube lock. To remove the accessory, press and hold the brush lock.
OPERATION
- Press the on/off switch, the appliance will start to work in the eco speed mode.
- Press the speed control button, the appliance will work in the high-speed mode.
- Press the speed control button again to return to the eco speed mode.
- Press AUTO to switch the automatic dust suction mode.
Note:
- When using, do not exceed the maximum line indicator in the dust cup.
- This appliance is for dry suction only.
- Ensure there is no clogging in any of the openings to avoid motor overheating and damage.
Battery Pack
- Insert the battery pack into the place along with the guide slot and ensure the battery pack is fixed firmly.
- To remove the battery pack, press the battery pack lock.
Charging
- Connect the charger to the battery pack and turn on the power supply to start charging.
- When charging, the charging indicator flashes blue light gradually and becomes solid when it is fully charged.
WARNING: Charge the battery with the charger supplied with the appliance to avoid damage.
CLEANING & CARE
- Never immerse the main unit in water or any liquid.
- Only use a soft, slightly damp cloth to clean the main unit. Do not allow any liquid substances to enter the main unit.
- Except for the main unit, other parts can be washed with warm soapy water. After cleaning, it must be thoroughly dried.
- Do not use any corrosive chemicals or abrasives.
- Do not use it when the filter is damaged or worn.
Cleaning Dust Cup
-
Empty the dust cup and clean the filter every time it is used.
-
Press and hold the dust cup lock to separate the dust cup.
-
Press and hold the dust release button to empty the dust in the dust cup.
Cleaning Filter
- Separate dust cup from the main unit.
- Remove the air inlet filter and wash it in warm water.
- Dry the filter for 24 hours before placing it back into the dust cup.
Note:
- Do not dry the filter with drying equipment. Dry naturally.
- Do not clean it with other cleaning equipment. Follow the instructions in this section.
- Replace the filter every three months (depending on the usage) to ensure the best performance.
TROUBLESHOOTING
Problem | Cause | Possible Solution |
---|---|---|
Weak Suction Power | Dust cups and filters are full of dust. | |
The brush head is blocked by hair. | Clean the dust cup and filters regularly. |
Clean the brush.
Abnormal Sounds| The aluminium tube is blocked| Clean the blockage inside of
the aluminium tube. If there are any abnormalities. contact Kogan.com
Charging Indicator tight Flashes| The brush or dust cup is blockage has caused
the current increase| Clean the blockage. See the Care section of this
Cleaning user guide.
Ambient temperature is too high or too low. causing the battery humidity to be
too high or too low
A different charger is used to charge the battery.| Ensure the appliance is
operated at the right temperature (0 – 55 ° C). using the Charge the battery
charger supplied with the appliance.
The brush is Not Working| The brush head is blocked by hair.| Clean the brush.
The appliance is Not Working| The battery power is low.| Charge the battery.
See the Operation section of this user guide.
The aluminium tube nozzle is blocked.| Clean the aluminium tube nozzle.
Automatic Mode Failure| The aluminium tube nozzle is blocked.| Clean the
nozzle regularly.
Disposal
| This marking indicates that this appliance should not be disposed of with
other
household wastes. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote
the sustainable reuse of material resources.
---|---
SPECIFICATIONS
Battery Configuration | Lithium-ion 2500mAh 29.6V |
---|---|
Rated Power | 300W |
Input Power | AC 100-240V, 50/60Hz 0.5A |
Output Power | DC 35V, 0.5A |
Charging Time | 5-6 Hours |
Operating Time | Maximum of 60 minutes (when the battery is fully charged) |
Protection Class | II |
NOTES
Need more information?
We hope that this user guide has given you
the assistance needed for a simple setup.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>