LEDLyskilder R14 Ultrathin Touch Slide RF Remote Controller Instruction Manual
- June 4, 2024
- LEDLyskilder
Table of Contents
LEDLyskilder R14 Ultrathin Touch Slide RF Remote Controller
Touch color slide/RGB+W/Wireless remote 30m distance/CR2032 battery/Magnet stuck fix
Features
- Apply to RGB+W LED controller.
- Ultra sensitive color adjustment touch slide.
- Each remote can match one or more receivers.
- CR2032 battery powered.
- Operate with LED indicator light.
- Magnet on the back which can be easily stuck on back holder or any metal surfaces.
Technical Parameters
Input and Output
Output signal| RF(2.4GHz)
Working voltage| 3VDC(CR2032)
Working current| <5mA
Standby current| <10μA
Standby time| 1 year
Remote distance| 30m(Barrier-free space)
Safety and EMC
EMC standard (EMC)| ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4
Safety standard(LVD)| EN 62368-1:2020+A11:2020
Radio Equipment(RED)| ETSI EN 300 328 V2.2.2
Certification| CE,EMC,LVD,RED
Environment
Operation temperature| Ta: -30 OC ~ +55 OC
IP rating| IP20
Mechanical Structures and Installations
To fix the remote, three options are offered for selection:
- Option 1: stuck the remote on any metal surfaces directly.
- Option 2: fix the remote’ back holder on the wall with two screws.
- Option 3: adhere the remote’ back holder to the wall with a paster
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
-
Match:
Short press the match key, and immediately press on/off key on the remote. The LED indicator fast flash a few times means the match is successful. -
Delete:
Press and hold the match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.
Use Power Restart
- Match:
Switch off the power, then switch on the power, and repeat again. An immediately short press on/off key 3 times on the remote. The light blinks 3 times means the match is successful.
Delete:
Switch off the power, then switch on the power, and repeat again. An immediately short press on/off key 5 times on the remote. The light blinks 5 times means all matched remotes were deleted.
Key function
- Short press for On/Off.
- Press and hold 1-6s for RGB brightness dimming.
- Fast press 2 times for shift between RGB, W, and RGB+W mode. In RGB or RGB+W mode, touch the slide to change the RGB color. In W mode, touch slide to change the white brightness.
Safety information
- Read all instructions carefully before you begin this installation.
- When installing the battery, pay attention to the battery’s positive and negative polarity. A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery.
- If no response from the receiver, please re-match the remote.
- Gently handle the remote, beware of falling.
- For indoor and dry location use only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>