LEDLyskilder R1-1 One Key RF Remote Controller User Manual
- June 4, 2024
- LEDLyskilder
Table of Contents
LEDLyskilder R1-1 One Key RF Remote Controller
Features
- Apply to single color LED controller.
- Each remote can match one or more receivers.
- CR2032 battery powered.
- Operate with LED indicator light.
- Magnet on the back which can be easily stuck on any metal surface.
Technical Parameters
Mechanical Structures and Installations
To fix the remote, three options are offered for selection:
- Option 1: stuck on any metal surfaces directly.
- Option 2: fix it on the wall with two screws.
- Option 3: adhere it to the wall with a paster.
Match Remote Control
End users can choose the suitable match/delete ways. Two options are offered for selection:
Use the controller’s Match key
-
Match:
Short press match key, immediately press on/off key on the remote. The LED indicator fast flash a few times means match is successful. -
Delete:
Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted.
Use Power Restart
-
Match:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key 3 times on the remote. The light blinks 3 times means match is successful. -
Delete:
Switch off the power, then switch on power, repeat again. Immediately short press on/off key 5 times on the remote. The light blinks 5 times means all matched remotes were deleted.
Safety information
- Read all instructions carefully before you begin this installation.
- When installing battery, pay attention to the battery’s positive and negative polarity. A long time without the remote control, remove the battery. When remote distance becomes smaller and insensitive, replace the battery.
- If no response from the receiver, please re-match the remote.
- Gently handle remote, beware of falling.
- For indoor and dry location use only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>