GP B631 Everyday Universal Charger (USB) 6-slot NiMH Instruction Manual
- June 6, 2024
- GP
Table of Contents
B631 Everyday Universal Charger (USB) 6-slot NiMH
Instruction Manual
Unpacking and checking
You should find the following items in the packaging*. Please make sure they are undamaged and in good working order.
*For exact items in the pack, please refer to the “In the box” section of the packaging.
Charging instructions
Charging conditions (Table 1)
LED indication (Table 2)
Charging conditions | LED Indicator |
---|---|
Charging in progress | Green (Flashing) |
Bad or single-use batteries | Green (Rapid flashing) |
Charging completed | Green |
Charging time (Table 3)**
Size | Capacity (mAh) | Charging time |
---|---|---|
AM | 650-950 mM | 2.5-4 hrs |
M | 1300-2600 mM | 4-8 hrs |
C | 3000 mM | 6 his |
D | 5700 mM | 11.5 hrs |
9V | 200 mAh | 6/12 hrs |
(1/2 channels)
Output voltage and current (Table 4)
DC 2.8V | Size | Output level |
---|---|---|
MA | 0.29 A x 2 | |
AA | 0.37A x 2 | |
C | 0.55 A x 2 | |
D | 0.55 A x 2 | |
9V | 40 mA / 20 mA |
1 channel / 2 channels
** Charging time is based on a 5V/2A wall charger or USB charging port. The charging time is subject to the power rating of the USB adapter and ambient temperature. A minimum rating of 5V/1A is required for a wall charger or USB port to start charging.
Features
- Charge 2 or 4 pcs of NiMH AAA / AA / C / D batteries and 1 to 2 pcs of 9V batteries
- Automatic charging current selection to ensure full charging of batteries
- 4 LED indicators (2 for AAA / AA / C / D batteries, 2 for 9V batteries) to show charging and battery status
- Auto power cut-off: negative delta V & safety timer
- Trickle charge mode
- Approx. charging time for 2 or 4 pcs of AAA 850 mAh / AA 2100 mAh batteries: 3–6 hours
Charging instructions
Read the instruction manual thoroughly before use. Keep the manual for future reference.
-
Connect the micro USB end of the USB charging cable to the micro USB port of the battery charger (Fig. 1a).
-
Connect the other end of the 5V / 2A USB charging cable to a 5V / 2A wall charger (Fig. 1b) or similar USB port for optimum performance.
-
Open the cover. Insert 2 or 4 pcs of AAA / AA / C / D and 1 to 2 pcs of 9V batteries into the battery charger according to the battery polarity (Fig. 2a and 2b).
For best charging performance, only use the battery combinations shown in Table 1. Charging will commence and the LED indicators will show the status of the batteries (Fig. 3 and Table 2). The LED indicators will flash green when the batteries are charging. For bad or single-use batteries, the LED indicators will flash green rapidly. Remove these batteries from the charger. -
Once the batteries are fully charged (LED constant green), remove the batteries and disconnect the battery charger from the power supply.
For best performance and safety, always use GP NiMH batteries.
Usage tips
- It is normal for batteries to become hot during charging and they will gradually cool down to room temperature after charging is complete.
- Remove batteries from the electrical device if the device is not going to be used for a long time.
- Battery storage temperature: -25 ~ +60°C
- Charging operation temperature: 0 ~ +35°C
- Recommend opening the cover during charging for better heat dissipation.
Safety information
- This charger is designed to charge NiMH batteries only. Charging other batteries may lead to an explosion, battery rupture or leakage, personal injury or property damage.
- This charger is designed for indoor use only. Do not expose the charger to rain, snow or direct sunlight.
- Do not use the charger in humid conditions.
- Make sure the charger is used between 0 ~ +35°C.
- Do not use non-rechargeable, LiFePO4, NiCD or Li-ion batteries.
- Do not use the charger if it has a damaged plug.
- Do not use the charger after it has been dropped or damaged. Do not open/disassemble the charger.
- Once the batteries are fully charged, recommend removing the batteries and disconnecting the battery charger from the power supply.
- In case a battery sleeve is damaged do not use it in the charger.
- Never remove the outer sleeve from batteries.
- Please use the charger in a well-ventilated place and ensure there are no other items covering the charger to avoid overheating. Do not stack up multiple chargers while charging.
- This charger is maintenance-free but should be wiped clean regularly with a dry and soft cloth. Do not use abrasives or solvents. Unplug the charger before cleaning.
- This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Do not dispose of electrical appliances as unsorted municipal waste, use
separate collection facilities. Contact your local government for information
regarding the collection systems available. If electrical appliances are
disposed of in landfills or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your health and well-being.
http://qrcode.gpbatteries.com/qrcode/global/Product/uni_chgr_m
Go to gpbatteries.com for product information
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>