DGL GROUP FB-TWGM Air True Wireless Earbuds User Guide
- June 6, 2024
- DGL GROUP
Table of Contents
AIR true wireless earbuds
quick start guide
CHARGING YOUR EARBUDS
Charge the earbuds before using them for the first time.
Charge the earbuds in the case for 1.5 hours.
If you hear a long beep, the earbuds need to be charged.
MUSIC CONTROLS
- Press the button once to pause your music.
- Previous Song: Double-tap the left earbud
- Next Song: Double-tap the right earbud
- Volume Up: Tap the left earbud 3x
- Volume Down: Tap the right earbud 3x
USING YOUR EARBUDS FOR CALLS
- Tap either earbud once to answer or end the call.
- Tap and hold either earbud to reject a call.
USING YOUR EARBUDS
Your earbuds will work best if it is within 30 k of your smart device. You may
experience the sound briefly cutting off if you are out of range or if your
wireless connection is weak.
Take the earbuds out of the charging case and they will
automatically turn on and pair with each other.
Turn on Bluetooth on your phone or tablet Choose ‘713-1M/GM”. Enter “0000” if
asked. You’re paired!
CONNECTION LOST?
- If only one earbud is working, press the other earbud for 3 seconds to reconnect
- If pairing two earbuds does not work, turn off the earbuds and repeat the steps again in “Using earbuds as a pair”.
- Make sure your earbuds are within range of your smart device.
- If you hear a long beep, you need to recharge your earbuds. The connection may be lost due to low battery
FCC STATEMENT
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. FCC ID:2AANZTWGM (Right Earphone), FCC
ID:2AANZTWGM-L (Left Earphone)