Dgl Group VTY99B Dynamic Wireless Headphone with Media Keys User Guide
- June 6, 2024
- DGL GROUP
Table of Contents
Dgl Group VTY99B Dynamic Wireless Headphone with Media Keys
CHARGING THE HEADPHONE
Charge the headphone before using Charge it for the first time.
Plug in the cable to the micro USB port and charge for at least 2 hours.
Connect the charging cable to charging part
PAIRING YOUR HEADPHONE
Your headphone will work best if it is within 33 ft. of your smart device. You
may experience sound briefly cutting off if you are out of range or if your
wireless connection is weak. Make sure Bluetooth is enabled on your smart
phone or tablet before starting the pairing process.
Make sure the headphone is turned off before attempting to pair it with a
smart phone or tablet.
- Press and hold the button on the earcup to turn on the headphone and you see the light flash red and blue. This indicates that your headphone is ready to pair.
- From your smart phone or tablet, find a list of nearby devices & choose HVTY-99BH Enter “0000” if osked. The headphone will flash a blue light when pairing is complete!
CONNECTION LOST?
- If pairing the headphone does not work, tum off the headphone and repeat the steps again in “Pairing your Headphone.”
- Make sure your headphone is within range of your smart device.
- If you hear a long beep, you need to recharge your headphone. Connection may be lost due to low battery.
- When charging your headphone, only use the enclosed USB cable.
WARNING
Keep aoNOy from v.oter and moisture. Keep aoNOy from heat sources.
Do not disassemble.
FCC ID: 2AANZVTY99B
BT ID: D044460
MEDIA KEY FUNCTIONS
- Upper Button
- PressOnce-
- Ploy/ Pause Music/
- Answer/End Incoming
- Phone Call
- Press Twice
- Redial Last Number
- Press& Hold
- Reject Call
- Middle Button
- Press& Hold
- Increase Volume
- Press Once-
- Next Track
- Lower Button
- Press& Hold
- Decrease Volume
- Press Once
- Previous Track
FCC STATEMENT
This device complies with port 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or on experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>