Dgl Group 17KR Travel Bass Wireless LED Speaker User Manual
- June 5, 2024
- DGL GROUP
Table of Contents
Dgl Group 17KR Travel Bass Wireless LED Speaker
Travel Bass Wireless LED Speaker
CHARGING THE SPEAKER
- Charge the speaker before using it for the first time.
- Plug in the cable to the micro USB port and charge V for 2 hours.
Connect the charging cable to charging port.
Travel Bass Wireless LED Speaker
FEATURES/PARTS
-
Retractable Trolley Handle
-
Carrying Handle
-
Mic Volume Adjustment Knob
-
Optional Mic Input
-
Volume Adjustment Knob
-
DC 5V / USB Charging Port
-
PowerOn/Off
-
Optional AUX-In
-
SD card Reader
NOTE:To switch between AUX, FM BT, USB and SD modes, press the “Mode” button. -
LED Display Panel
-
USB Reader
-
Mode Button
-
Previous Track
-
Piaf / Pause
-
next track
-
LED Light Panel/ Speaker
-
2 Castor Wheels {Rear of a speaker)
PAIRING YOUR SPEAKER
Your speaker will work best if it is within 30 ft. of your smart device. You may experience sound briefly cutting off if you are out of range or if your wireless connection is weak. Make sure Bluetooth is enabled on your smartphone or tablet before starting the pairing process.
- Turn on the speaker by flipping the Power Switch to the “On” position. The speaker will “beep when it is ready to connect.
- From your smart phone or tablet, find a list of nearby devices and choose “DG-17KR”. Enter “0000” if asked. The speaker will ubeepn again when pairing is complete!
SPECIFICATIONS
Bluetooth®: vs.a
Impedance: 3 Ohms
Speaker Frequency: 150HZ~18KHz
FM Channel Range: 87.5-108.0MHZ
Play nme: 1.5 hours
Speaker Power: 10W
Battery: 1500mAh
Charging Time: 5 – 6 hours
WARNING
Keep away from water and moisture.
Keep away from heat sources.
Do not disassemble.
FCC ID: 2AANZ17KR
BT ID:D044460
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>