Dgl Group GEBL Gaming LED Wireless Earbuds User Manual
- June 5, 2024
- DGL GROUP
Table of Contents
QUICK START GUIDE
Gaming LED Wireless Earbuds
CHARGING THE EARBUDS
Charge the earbuds before using it for the first time.
Plug in the cable to the micro USB port and charge for at least 2 hours.
Connect the charging cable to the charging port.
PAIRING YOUR EARBUDS
Your earbuds will work best if they are within 30 ft of your smart device. You may experience sound briefly cutting off if you are out of range or if your wireless connection is weak. Make sure Bluetooth is enabled on your smartphone or tablet before starting the pairing process.
PAIRING YOUR EARBUDS (continued)
Make sure the earbuds are turned off before attempting to pair it with a smart
phone or tablet.
Press and hold the “Multifunction” button for 5 seconds to turn on the earbuds. You will see the light flash red and blue. This indicates that your earbuds are ready to pair.| From your smartphone or tablet find a list of nearby devices and choose “FB-GEBL”.Enter “0000” if asked. The earbuds will flash blue light when the pairing is complete!
CONNECTION LOST?
- If pairing the earbuds does not work, turn off the earbuds and repeat the steps again in Pairing your Earbuds.”
- Make sure your earbuds are within range of your smart device.
- If you hear a long beep, you need to recharge your earbuds. The connection may be lost due to low battery.
- When charging your earbuds, only use the enclosed USB cable.
MEDIA KEY FUNCTIONS
SPECIFICATIONS
Wireless Distance:
Play Time:
Talk Time:
Standby Time:
Battery Capacity:
Charging lime:
BT ID:
FCC ID:| Up to 33ft (10m)
Up to 3 hours
Up to 3 Hours
Up to 50 hours
3.7V 80MAH
About 3 Hours
D051448
2AANZGEBL
---|---
WARNING Keep away from water and moisture. Keep away from heat sources.
Do not disassemble. operating temperature range: 0-45 C
CAUTION: PCB of the battery should not be crushed and twisted. The battery
body should not be Bended. Do not disassemble and Do not dispose of in fire
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
- This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>