Dgl Group TWRC Wireless Earbuds and Charging Case User Guide

Dgl Group TWRC Wireless Earbuds and Charging

USING THE PORTABLE CHARGING CASE

We recommend that you keep the earbuds in the portable charge case when not in use. While on-the-go, the case doubles as a charging solution for the earbuds. Simply put the earbuds into the charging case. The earbuds will be powered automatically, a full charge of the earbuds takes about 2 hours.

Connect the Micro USB cable to the charging port on case. A full charge of the case battery takes up 2 hours. When the case is charging, the LED light flashes red. The red light will turn to red when fully charged.

1. Your earbuds come pre-paired. If they lose connection, please follow the below steps to reconnect. Press and hold multifunction buttons on both earbuds to power on both earbuds, then wait till the indicator lights flash blue slov.1y on both earbuds.
2. Tum on Bluetooth on your phone or tablet, Choose “DG-TWRC”. Enter “0000” if asked. You’re paired! Both earbuds flash blue every 6 seconds.
3. To tum OFF press and hold the mult,funct, on the button on both earbuds until the LED flashes red .

USING EARBUDS FOR DIFFERENT DEVICES

The earbuds can be paired to different devices, For example, you can use one earbud with a smartphone and the other earbud for a tablet,

1. Turn on one earbud by pressing and holding the multifunction button for 3 seconds, The earbud flashes red and blue, Leave the other earbud fumed off.
2. Select “DG-TWRC” from the Bluetooth menu of your first device, Enter PIN code ‘CTXJJ’ if asked, This earbud is ready to use.
3. To pair the other earbud, make sure your other wireless device is nearby. Same pairing operation as the first earbud. Choos e”DG-TWRC”. Enter “0000” if asked.

MUSIC CONTROLS

• Press the button once to pause your music.
• Volume control is only through your smart phone or wireless device,

USING YOUR EARBUDS FOR CALLS

• Press the button once to answer or end call.
• Press and hold the button to reject a call.

NOTE: When answering calls, tihe call can be heard and controlled by both earbuds.

CONNECTION LOST?

• If only one earbud works, turn off the earbud and reconnect earbuds as a pair,
• If paired two earbuds don’t work, turn off the earbud and reconnect earbuds as a pair,
• Make sure your earbuds are within range of your smart device,
• If you hear a short beep every 30 seconds, you need to recharge your earbuds, Connection may be lost due to low battery,

FCC STATEMENT

This device complies whe part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna,
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,
• Consult the dealer or an experienced radio/TV technician for help,

WARRANTY This product is covered by a 3-month limited manufacturer’s warranty. Contact us if you have any problems at support@dglusa.com.

WARNING Keep away from water and moisture. Keep away from heat sources. Do not disassemble.

RF warning statement The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>