AFTERSHOKZ C102 OpenComm Bone Conduction Open-Ear Stereo Bluetooth Headset User Manual
- June 6, 2024
- AfterShokz
Table of Contents
AFTERSHOKZ C102 OpenComm Bone Conduction Open-Ear Stereo Bluetooth Headset
Storage and Maintenance
- Store the headset in a cool. dry place. The working temperature should be 0-45°C(32- 113°F). Working in a cold/hot environment a highly humid area. or on extremely low air pressure may reduce the battery life.
- Keep the product away from heat sources. direct sunlight. combustible gas or other liquids.
- Keeping the charging port dry before connecting to the charger will reduce the risk of damage.
- This headset is water-resistant. but is not waterproof. Please do not submerse the headset in water.
- Cleon the headset with a soft dry cloth.
- Do not charge right after exercising. in case there’s sweat inside the charging port, which could lead to circuit burning while charging.
- After storage for a long period. please charge the headset before using again.
Note
Design and specification ore subject to change without notice. For the most
up-to-dote product information. please visit www.shokz.com.
Hearing Loss
Listening with headset at high volume may affect your hearing and the audio will be distorted.
Warning
To avoid the risk of explosion. fire, or leakage from toxic chemicals, please do not disassemble the product or replace. deform. or mutilate the battery.
FCC
FCC Caution
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment This
device complies with Port 15 of the
FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received. including interference
that may cause undesired operation.
FCC Statement
This equipment hos been tested and found to comply with the limits for a Closs
B digital device. pursuant to port 15 of the FCC Rules. These limits ore
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and. if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception. which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or on experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment
Resposible party (contact for FCC matters only): AfterShokz. LLC.
3200 Gracie Kiltz Lane, Suite 400 Austin, TX 78758 USA www.shokz.com
Industry Canada
This device complies with Industry Canada licence-exempt RSS stondard(s): Operation is subject to the following Two conditions: (1) this device may not cause interference. and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
IC SAR statement
This equipment complies with ISED radiation exposure limits set forth for on uncontrolled environment End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the head.
CE Declaration of Conformity
Shokz Holding Limited hereby declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU and all other applicable EU Directive requirements. The complete declaration of conformity con be found at https://shok:z.com/poges/policies. Shokz’s EU representative is AfterShokz Euro B.V, Schipholweg 103, 2316XC Leiden, Netherlands.
Frequency Range | Mox. Transmit Power |
---|---|
2400-2483.5MHz | 9dBm(EIRP) |
UK Declaration of Conformity
Shokz Holding limited hereby declares that this product is in compliance with the essential requirements and all other applicable United Kingdom’s regulations. The complete declaration of conformity con be found at https://shokz.com/poges/policies. Shok:z’s authorised representative in the UK is Pinpoint Consumer Electronics Ltd., Unit 35, Meridian House, Rood One, Winsford Industrial Estate, Winsford, Cheshire CW? 3QG.
WEEE Declaration of Conformity
This WEEE logo means that this product must not be discarded as household waste, and should -be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources. human health and the environment For more information on disposal and recycling of this product, contact your local municipality, disposal seivice, or the shop where you bought this product
Manufacturer Declarations
Warranty: Shokz Holding Limited gives o warranty of 24 months on this product. For the current warranty conditions, please visit our website at www.shokz.com or contact your Shok:z partner. Before putting the product into operation, please observe the respective country specific regulations
Australia/New Zealand
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>