FULAIM X5 Wireless Lavalier Microphone User Manual

FULAIM X5 Wireless Lavalier Microphone User Manual

Overview

Thank you for choosing our Wireless Microphones.
This device adopts 2.4G AFH (adaptive frequency hopping) and innovative digital wireless low-latency technology, provides high quality audio, stable and reliable signal transmission. It can be widely used in interviews, short video recordings, program hosting, live streaming, teaching and training, and other wireless applications.

What’s in the box

I. User interface of transmitter (TX)

II. User interface of receiver (RX)

TFT display of receiver

III. Matching

When TX and RX cannot be connected, follow the steps below for re- matching:

1. TX: Turn on the transmitter, press al’\d hold the power button and SET button at the same timefor2 seconds, the power indicator will flash shows the transmitter enters the matching mode (if there are two TXs, just operate same as above); then go to step 2.
2. RX: Tum on the receiver, press and hold the power button and SET button at the same time for2 seconds, the signal indicator on the display parielofthereceiverwillflashshowsthereceiverentersthematchingmode.
3. Wait till the indicator of both TX and RX stop flashing,, the matching is complete.

IV. Start using

RX- How to use on cell phone: Connect the Type-C Port of the RX with the Port of the cell phone by using the Type-C OTG adapter or Lightning OTG adapter

*For some cell phones with Type-C Port, you need to turn on the OTG function in the phone setting section

RX- How to use on other devices:

1. Connect the Type-C Port of the RX with the Type-C/USB Port of the laptop by using the Type-C OTG adapter
2. Connect the “OUT” Porto the RX with the “MIC IN” or “LINE IN” Porto the audio interface by usingthe3.Smm camera audio cable

V. Built-in 4GB of internal storage in transmitter, which can handle up

to 9 hours of audio

Long press the SET button of the transmitter for 2 seconds to start/end the recording. This function is only used for audio backup. Recording files are automatically saved/deleted in cycles.

• Storage space is about 4GB
• Recording files are exported by using the Type-C cable

VI. Precautions

1. This product is a precise electronic device, which should avoid water or heavy fall, if it gets wet, please dry it in time, and hand it up to professional technician for further checking.
2. When not using for a long time, the built-in rechargeable Li-battery should be fully charged every three months to maintain the high performance of the battery.
3. The built-in battery must not be exposed to sunlight, fire, or similar overheating environment.
4. lf TX/RX cannot be shut down, press and hold the power button for 8 seconds to reset.
5. To avoid intermittent signal, please try to keep the transmitter and receiver face to face while using.

VII. Specifications

Frequency range: 2402- 2480 MHz
Modulation: GFSK
Frequency response: 30 Hz- 20 kHz
Audio latency: ⪁ 20 ms
Transmit power: ⪁ 10 dBm
Power supply: DC 3.7V (built-in Li-battery)
Recharging input: 5V= 500mA
Power management: Shut down automatically after 5 minutes no connection
Operating temperature: 0°c to + 55°c
Storage temperature: -20°C to +SS”C
Dimensions: 47 26 13 mm (TX); 47 29 14 mm (RX)
Net weight: Approx. 18g (TX); approx.2lg (RX)

Charging case:

Recharging input: 5V= 2A
Power supply: DC 3.7V/2000mAh (built-in Li-battery)

Opening the lid can activate indicator to check the remaining battery power
Closing the lid will enter the charging mode automatically
A fully charging case can charge TX+TX+RX for2 times
Opening the lid will automatically turn on the TX and RX in the charging case; closing the lid will automatically turn off the TX and RX in the charging case

FCC Caution.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. lf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.

*RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable

◊The image shown here is indicative only. If there is inconsistency between the image and the actual product, the actual product shall govern.
◊We reserve the rights to improve product and product copyright information without prior notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>