Aftershokz AS650MB Air Bone Conduction Wireless Bluetooth Headphones User Manual
- June 6, 2024
- AfterShokz
Table of Contents
Aftershokz AS650MB Air Bone Conduction Wireless Bluetooth Headphones
Storage and Maintenance
- Store the headphones in a cool, dry place. The working temperature should be 0~45°C(32~113°F). Working in a cold/hot environment, a highly humid area, or an extremely low air pressure may reduce the battery life.
- Keep the product away from heat sources, direct sunlight, combustible gas or other liquids.
- Keeping the charging port dry before connecting to the charger will reduce the risk of damage.
- The headphones can be used for daily cleaning, but it cannot be rinsed and soaked against the microphone hole, otherwise it may affect the performance of the microphone.
- Clean the headphones with a soft dry cloth.
- Do not charge right after exercising, in case there’s sweat inside the charging port, which could lead to circuit burning while charging.
- After storage for a long period, please charge the headphones before using again.
Note: Design and specification are subject to change without notice. For the most up-to-date product information, please visit www.shokz.com.
Hearing Loss
Listening with headphones at high volume may affect your hearing and the audio
will be distorted.
Warning
To avoid the risk of explosion, fire, or leakage from toxic chemicals, please
do not disassemble the product or replace, deform, or mutilate the battery.
FCC
FCC Caution
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without testing of specific absorption rate (SAR).
Resposible party (contact for FCC matters only):
AfterShokz LLC.
3200 Gracie Kiltz Lane, Suite 400 Austin, TX 78758 USA www.shokz.com
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s):
Operation is subject to the following Two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
CE Declaration of Conformity
Shokz Holding Limited hereby declares that this product is in compliance with
the essential requirements and other relevant provisions of Directive
2014/53/EU and all other applicable EU Directive requirements. The complete
declaration of conformity can be found at: https://shokz.com/pages/policies.
Shokz’s EU representative is AfterShokz Euro B.V., Schipholweg 103, 2316XC
Leiden, Netherlands.
Frequency Range Max. Transmit Power
2400-2483.5MHz 5.5dBm(EIRP)
UK Declaration of Conformity
Shokz Holding Limited hereby declares that this product is in compliance with
the essential requirements and all other applicable United Kingdom’s
regulations. The complete declaration of conformity can be found at:
https://shokz.com/pages/policies. Shokz’s authorised representative in the
UK is Pinpoint Consumer Electronics Ltd., Unit 35, Meridian House, Road One,
Winsford Industrial Estate, Winsford, Cheshire CW7 3QG.
WEEE Declaration of Conformity
This WEEE logo means that this product must not be discarded as household
waste, and should be delivered to an appropriate collection facility for
recycling. Proper disposal and recycling helps protect natural resources,
human health and the environment. For more information on disposal and
recycling of this product, contact your local municipality, disposal service,
or the shop where you bought this product.
Manufacturer Declarations
Warranty: Shokz Holding Limited gives a warranty of 24 months on this
product. For the current warranty conditions, please visit our website at
www.shokz.com or contact your Shokz partner. Before putting the product into
operation, please observe the respective country specific regulations.
Australia/New Zealand
Documents / Resources
|
Aftershokz AS650MB Air Bone Conduction Wireless Bluetooth
Headphones
[pdf] User Manual
ASCEHB7, SHKASCEHB7, AS650MB, Air Bone Conduction Wireless Bluetooth
Headphones
---|---