MONACOR CRB-130SET 2-Way Car HiFi Speaker System Instruction Manual

: June 6, 2024
: MONACOR

Table of Contents

MONACOR CRB-130SET 2-Way Car HiFi Speaker System
Applications
Safety Notes
Setting into Operation
Specifications
Installation
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MONACOR CRB-130SET 2-Way Car HiFi Speaker System

Please read these operating instructions carefully prior to operation and keep them for later use.

Applications

This high-quality speaker set is especially designed for the use in car HiFi systems and consists of:

2 x bass-midrange speaker Ø 130 mm or 165mm
2 x tweeter, can be tilted inside its cabinet
2 x 2-way crossover network

The following power capabilities of the components per channel must not be exceeded:
CRB-100SET: 100WMAX, 50WRMS
CRB-130SET: 130WMAX, 65WRMS

Safety Notes

The crossover networks and the speakers correspond to all required directives of the EU and are therefore marked

The components are suitable for indoor use only. Protect them against dripping water and splash water, high air humidity, and heat (admissible ambient temperature range 0 – 40 °C).
For cleaning only use a dry, soft cloth, by no means chemicals or water.
The components must be mounted in a firm and competent way at a mechanically stable place in the car so that they do not work loose and turn into dangerous projectiles.
No guarantee claims for the components and no liability for any resulting personal damage or material damage will be accepted if the components are used for other purposes than originally intended, if they are not correctly connected, overloaded, or not repaired in an expert way.

If the components are to be put out of operation definitively, take them to a local recycling plant for a disposal which is not harmful to the environment.

Setting into Operation

Mounting the crossover network
Press in the upper shell of the housing in the centre on one side in a powerful way [see arrow (a) or (b) in the figure below] so that one of the two latches will unlock. Then it is possible to remove the upper shell.
Now the two fixing holes inside are accessible. Screw down the crossover network at a suitable place.
Do not reposition the upper shell of the housing until the level for the high frequencies has been matched (see chapter 3.3).
Connection
The connection of the speaker set for one channel is shown below. The connection for the second channel is identical. Always connect the coded core of the connection cables to the corresponding positive pole so that all speakers have the same polarity for the time being.
Connect the output of the power amplifier to the connections INPUT of the crossover network.
Connect the bass-midrange speaker to the terminals WOOFER.
Connect the tweeter to the connections TWEETER.
Making the adjustments
The jumper on the PCB of the crossover network serves for level matching the high frequencies. (To open the housing, see chapter 3.1.) In position -3dB or -6 dB the high frequencies are attenuated accordingly. Close the housing of the crossover network.
The polarity of the tweeters may be reversed by exchanging the positive connections and the negative connections TWEETER at the crossover network. This may result in a better sound for some car HiFi systems.