HYUNDAI FOB-4F53U FOB Smart Key Instruction Manual
- June 6, 2024
- HYUNDAI
Table of Contents
Manual for the vehicle manufacturer
Model name: FOB-4F53U, FOB-4F54UA, FOB-4F55U, FOB-4F56UA
OUTLINE
-
How to use FOB-4F53U, FOB-4F54UA, FOB-4F55U, FOB-4F56UA
– FOB-4F53U, FOB-4F54UA, FOB-4F55U, FOB-4F56UA are a part of Remote Keyless System.
– This unit controls door lock/door unlock/trunk open/panic/remote engine start-stop/ forward/backward/battery charging door open wirelessly. -
Introduction of Transmitter (FOB-4F53U, FOB-4F54UA, FOB-4F55U, FOB-4F56UA)
– These units use the battery
– Frequency is 433.92MHz, 6.5GHz
GENERAL DESCRIPTION
PRIMARY FUNCTION – Remote door lock/door unlock/trunk open/panic/remote engine start-stop/forward/backward/ battery charging door open – Operating voltage: 3V DC – Center freq.: 433.92MHz, 6.5GHz
MANUAL
-
LOCK Button
If the LOCK button is pressed, then TRANSMITTER sends the LOCK data. -
UNLOCK Button
If the UNLOCK button is pressed, then TRANSMITTER sends the UNLOCK data. -
TRUNK Button
If the TRUNK button is pressed, then TRANSMITTER sends TRUNK data. -
PANIC Button
If the PANIC button is pressed, then TRANSMITTER sends PANIC data. -
Remote Engine Start-Stop Button
If the Remote Engine Start-Stop Button is pressed, then TRANSMITTER sends the Remote Engine Start-Stop data. -
FORWARD Button
If the FORWARD button is pressed, then TRANSMITTER sends the FORWARD data. -
BACKWARD Button
If the BACKWARD button is pressed, then TRANSMITTER sends BACKWARD data. -
Battery Charging Door Open Button
If the Battery Charging Door Open Button is pressed, then TRANSMITTER sends Battery charging door open data.
FCC/ISED NOTICE
[FCC] This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution: Any changes or modifications to this device not explicitly approved
by the manufacturer could avoid your authority to operate this equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be collocated or operating
in conjunction with any other antenna or transmitter unless authorized to do
so by the FCC [ISED] This device contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the
following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.