HYUNDAI FOB-4F53M Smart Key Instructions
- June 6, 2024
- HYUNDAI
Table of Contents
Manual for the vehicle manufacturer
Model name: FOB-4F53M, FOB-4F54MA, FOB-4F55M, FOB-4F56MA
OUTLINE
-
How to use FOB-4F53M, FOB-4F54MA, FOB-4F55M, FOB-4F56MA
‐ FOB-4F53M, FOB-4F54MA, FOB-4F55M, FOB-4F56MA are a part of Remote Keyless System.
‐ This unit controls door lock/door unlock/trunk open/panic/remote engine start-stop/forward/ backward/battery charging door open wirelessly. -
Introduction of Transmitter (FOB-4F53M, FOB-4F54MA, FOB-4F55M, FOB-4F56MA)
– These units use the battery
‐ Frequency is 433.92MHz
GENERAL DESCRIPTION
PRIMARY FUNCTION
‐ Remote door lock/door unlock/trunk open/panic/remote engine start-
stop/forward/backward/ battery charging door open
‐ Operating voltage: 3V DC
‐ Center freq.: 433.92MHz
MANUAL
-
LOCK Button
If the LOCK button is pressed, then TRANSMITTER sends the LOCK data. -
UNLOCK Button
If the UNLOCK button is pressed, then TRANSMITTER sends the UNLOCK data. -
TRUNK Button
If the TRUNK button is pressed, then TRANSMITTER sends TRUNK data. -
PANIC Button
If the PANIC button is pressed, then TRANSMITTER sends PANIC data. -
Remote Engine Start-Stop Button
If the Remote Engine Start-Stop Button is pressed, then TRANSMITTER sends the Remote Engine Start-Stop data. -
If the FORWARD button is pressed, then TRANSMITTER sends the FORWARD data.
FORWARD Button -
If the BACKWARD button is pressed, then TRANSMITTER sends BACKWARD data.
BACKWARD Button -
Battery Charging Door Open Button
If the Battery Charging Door Open Button is pressed, then TRANSMITTER sends Battery charging door open data.
FCC/ISED NOTICE
[FCC]
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Caution: Any changes or modifications to this device not explicitly
approved by the manufacturer could avoid your authority to operate this
equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be collocated or operating
in conjunction with any other antenna or transmitter unless authorized to do
so by the FCC
[ISED]
This device contains license-exempt transmitter(s)/receiver(s) that comply
with innovation, Science, and Economic DevelopmentCanada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment.
This transmitter must not be collocated or operating in conjunction with any
other antenna or transmitter unless authorized to do so by the ISED