concept KF1320 Titan Care 4-V-1 Air Styler User Guide
- June 6, 2024
- concept
Table of Contents
concept KF1320 Titan Care 4-V-1 Air Styler
Acknowledgements
Thank you for purchasing a Concept product. We wish you much joy with your new
appliance every day you use it. Please read the instruction manual carefully
before initial use. To refer to this manual any time you need to, we recommend
you to keep it in a safe place. And please pass it to any future owner of the
appliance.
Technical specifications
- Voltage 220-240 V, 50/60 Hz
- Input 600 W
- Sound performance level 67 dB
IMPORTANT SAFETY PRECAUTIONS
-
Do not use the appliance in any other way than as described in this manual.
-
Remove all the covering and marketing materials from the appliance before the first use.
-
Make sure the mains voltage corresponds to the values on the rating plate of the appliance.
-
For additional protection, it is recommended to install a residual current device (RCD) with a rated trip current not exceeding 30 mA in the bathroom electrical circuit. Contact an electrician for advice.
-
The appliance is hot during operation and for some time after switching off. Therefore, do not touch hot surfaces. Use handles and buttons. There is risk of serious burns!
-
Do not clean, store or cover the appliance until it has cooled completely.
-
Do not leave the appliance unattended when it is switched on or connected to the mains.
-
If you put the appliance down during use, always switch it off and place it on a non-flammable surface.
-
Before connecting or disconnecting the appliance from the mains socket, make sure that the switch is in the off position.
-
When disconnecting the unit from the wall outlet, never pull the power cord, grasp the plug end and disconnect it by removing it from the receptacle.
-
Do not allow children or unauthorized people to handle the appliance, use it out of their reach.
-
Persons with reduced mobility, reduced sensory perception, mental disadvantage or persons not familiar with the operation must use the appliance only under the supervision of responsible person, who is familiar with the instructions.
-
Pay extra attention if the appliance is used near children.
-
Do not use the appliance as a toy.
-
Before cleaning and after use of the appliance, switch the appliance off, disconnect it from the mains and allow it to cool down.
-
Do not allow the power cord to hang freely over the edge of the table. Do not allow the power cord to touch hot surfaces.
-
Do not allow the appliance to hang on the power cord.
-
Do not use the appliance in an environment where there are explosive gases and flammable substances (solvents, varnishes, adhesives, etc.).
-
Do not use hair spray or other spray products while the appliance is in operation.
-
Keep the appliance clean, do not allow foreign objects to into the grid openings. It could cause short circuit, damage to the appliance or cause fire.
-
Do not cover the inlet and outlet grilles of the appliance during operation.
-
Do not use coarse and chemically aggressive substances to clean the appliance.
-
Do not use the appliance if it is not working properly, has been dropped, damaged or immersed in liquid. Have it checked and repaired by an authorized service centre.
-
Do not use the appliance with a damaged power cord or plug, have the fault repaired immediately by an authorized service centre.
-
Do not wrap the power cord around the appliance body.
-
Do not use the appliance outdoors.
-
Do not immerse the power cord, plug or appliance in water or any other liquid.
-
Do not use any accessories other than those recommended by the manufacturer.
-
Do not repair the appliance yourself. Contact an authorized service centre.
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Cleaning and maintenance performed by the user must not be carried out by children unless they are 8 years old and under supervision. Children aged under 8 years of age must be kept away from the appliance and its power cord. Do not let children play with the appliance.
Damages from failure to follow the manufacturer’s instructions are not covered by the warranty.
CAUTION:
Do not use the appliance near bathtubs, washbasins and other containers filled
with water. If you use the appliance in the bathroom, be sure to switch it off
and unplug it immediately after use, as the proximity of water and the
appliance’s contact with water is very dangerous, even when the appliance is
turned off.
Do not touch the appliance with wet hands and do not handle it if you have wet
feet or if you are barefoot.
PRODUCT DESCRIPTION
Model KF1320
- Main part
- On/Off switch
- Operation indicator
- Bristle retraction lever
- Swivel cord
- Hanging loop
- Round brush
Model KF1325
- Main part
- On/Off switch
- Operation indicator
- Attachment release button
- Swivel cord
- Hanging loop
- Concentrator
- Round brush
- Brush
- Volume brush
OPERATING INSTRUCTIONS
- On/Off switch: 1st level = off / 2nd level = lowest temperature, strong blowing / 3rd level = higher temperature, weak blowing / 4th level = highest temperature, strong blowing
- Inserting the attachment: – simply insert the brush attachment the main part. / KF1325 – Insert the attachment into the main part so that it snaps into the notch behind the attachment release button (4), press the attachment button (4), then insert the attachment and turn it slightly.
- Removing the attachment: KF1320 – simply pull the attachment out of the main part. / KF1325 – press the attachment release button (4), turn the attachment slightly and pull it out of the main part.
- Cleaning: The air styler may be cleaned with a damp cloth. The brushes may be cleaned with a small coarse brush and a dry cloth.
- Placement: The hanging loop allows the appliance to be hung on the wall.
DISPOSAL
Packaging :
Box – separate collection of paper
PE bag – separate collection of PE
Polystyrene padding – separate collection of PS
Product :
Plastics – separate collection of plastics
Cord without plug – separate collection of copper
Metal parts, electronics – metal scrap
CLEANING AND MAINTENANCE
WARNING!
Before each cleaning of the appliance, unplug the power cord from the
electrical outlet!
Make sure the appliance has cooled before handling it!
To clean the surface of the appliance, use only a damp cloth, no detergents or
hard objects, as they can damage the surface of the appliance!
Never clean the appliance under running water, do not rinse it or immerse
it in water!
SERVICE CENTRE
Extensive maintenance or repair, which requires access to internal parts of
the product, has to be performed by a qualified service centre.
ENVIRONMENTAL CONCERNS
- Packaging materials and old appliances should be recycled.
- Packaging materials may be disposed of as sorted waste.
- Dispose the plastic bags made of polyethylene (PE) of as sorted waste.
Recycling of the appliance at the end of its lifespan
This appliance is labelled in accordance with European Directive 2012/19/EU concerning used electrical and electronic appliances (waste electrical and electronic equipment – WEEE). The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product. The
disposal of such material has to be done according to the recycling
regulations. For more detailed information about recycling of this appliance
see the authorized local office or service for household waste disposal or the
shop, where you purchased the appliance.
The product meets all the necessary requirements of the EU directives
applicable to the specific product.
Changes in text, design, and technical specifications are subject to change without notice and we reserve the right to change them.
WARRANTY TERMS
Warranty
The manufacturer (or importer) is responsible for ensuring the product
complies with the requirements of applicable legal regulations as well as
those of the relevant technical standards. Moreover, they are responsible for
ensuring the product has the properties the manufacturer described in
documents related to the goods or those reasonably expected by the customer
with regard to the nature of the goods or based on advertising produced by the
manufacturer, and further they are responsible for ensuring the product is fit
for the purpose proposed by the manufacturer or that a product of the same
type is normally used for.
The quality warranty term is 24 months from product takeover by the customer.
The warranty does not apply to wear and tear caused by regular use. The
customer shall not be entitled to any warranty claims if, prior to taking the
product over, they knew the product contained a defect or if the defect is
attributable to the customer.
The warranty specifically does not apply:
-
if the product installation, operation and service conditions stipulated in the product operating manual have not been adhered to,
-
to malfunctions caused due to mechanical, heat or chemical damage, short circuit, over voltage or incorrect installation,
-
to malfunctions caused by an inexpert third-party intervention,
-
to malfunctions caused by natural disaster,
-
to malfunctions caused by insufficient or inappropriate maintenance in violation of the operating manual, including malfunctions caused by water and other sediments,
-
to changes in colour of the heating surface or to scratching of the surface caused as a result of using the products in an unusual manner,
-
to appearance and functional changes caused by exposure to sunlight, thermal radiation of water and other sediments,
-
if the service life of certain product parts expires, e.g. for accumulators, bulbs, etc.
The warranty does not apply to any products and services provided along with the product (gifts, promotional articles, etc.).
Filing a complaint
A complaint against a product defect must be filed as soon as identified, yet
no later than before the end of the warranty term.
The customer must file a product complaint with the dealer from which they
have purchased the product, or with any authorised service centre, a list of
which is included in the product package, or available at www. my-
concept.com.
While filing a product complaint, the product must be duly cleaned and
securely packed so as to prevent any damage during its transport to an
authorised service centre, where relevant, unless the product is delivered in
person.
The customer must submit proof of having concluded a purchase contract for the
product by producing the receipt.
While filing their complaint, the customer must indicate the noted defect and
identify the preferred complaint application method.
Complaints processing
As long as the noted defect may be removed, the user has the right to have the
defect duly removed free of charge on a timely basis.
Where such a procedure is not reasonable with regard to the nature of the
defect, the user may require to be supplied a new defect-free product
(replacement), or, where the defect applies to a part of the product only,
replacement of the part concerned. However, if replacement of the product or
any part thereof is not proportionate with regard to the nature of the defect,
especially if the defect can be removed without undue delay, the customer has
the right to have the defect removed free of charge.
If the noted defect is not removable, or if the customer becomes entitled to
replacement of the product or a part thereof, yet the replacement is not
possible, for example due to the product having been sold out, the customer
has the right to return the product (withdrawal from the contract).
The customer shall have the right to a new product (replacement) or to
replacement of a part of the product even if the defect can be removed,
provided they cannot properly use the product due to repeated occurrence of
the defect or due to a high number of such defects. In such a case, the
customer also has the right to return the product (by withdrawing from the
contract).
If the product is not returned (the customer does not withdraw from the contract), or if the customer does not apply the right to a new defect-free product (replacement), to replacement of a part thereof or to repair of the product, they may request a reasonable discount. The customer also has a right to a reasonable discount if a new defect-free product cannot be supplied to them, or if a product part cannot be replaced or the product repaired unless the situation is remedied within a reasonable time limit, or if remedying the situation would create major discomfort on the part of the customer.
The seller, authorised service centre or a staff member authorised by them must decide about each complaint immediately or within three business days in complicated cases. This term does not include a reasonable period of time, depending on the type of product concerned, required for the defect to be assessed by an expert. A complaint, including defect removal, must be dealt with without any undue delay, yet no later than within 30 calendar days of the complaint filing date, unless the seller and the customer agree on a later deadline.
On returning the product (withdrawing from the contract) the customer must
return any accessories and documents supplied along with the product.
The customer does not have the right to keep the defective parts and
components of the product replaced as part of a repair of the product.
This shall be without prejudice to any other rights the customer may have in
relation to the purchase of the product.
Remark: Complaints against products damaged in transport are governed by
the carrier’s complaints procedure.
Manufacturer
Jindřich Valenta – Concept
Vysokomýtská 1800, 565 01 Choceň
Czech Republic
tel.: +420 465 471 400
fax +420 465 473 304
Company ID No. 13216660
email: servis@my-concept.cz
www: www.my-concept.com
Product data
- Model:
- Production number:
- Date of purchase:
- Seal and signature of vendor:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>