SCHLAGE BE467F Smart Deadbolt Instruction Manual
- June 6, 2024
- Schlage
Table of Contents
Installation Instructions Schlage Control™
Smart Deadbolt
Model BE467F
Tools Needed
- Phillips screwdriver
- Tape measure
Optional
- Flathead screwdriver
- Torx™ screwdriver
Door preparation:
See template in package.
Contact Product Support
1-877-671-7011.
ENGAGE™ WEB & MOBILE APPLICATIONS
Search for “Allegion ENGAGE” in the Apple App Store or Google Play store to
download the app.
Navigate to portal.allegionengage.com to
access your account online.
Access online interactive instructions, user guide, warranty, and reference information.
IMPORTANT NOTES
- Install and test lock with door open to avoid being locked in or out.
CAUTION
Use provided bolt!
Do NOT use a power drill for installation!
Check door dimensions.
See consumer.schlage.com/Service-Support for door preparation instructions if dimensions are
different.
Install the lock
Install bolt and strike.
CAUTION
Use provided bolt!
1a Adjust bolt length, if necessary.
Measure the backset. If the measurement is 2C\,” (60 mm) no adjustment is necessary.
If the measurement is 2C\v” (70 mm), extend the bolt.
1b If desired, change to the square-corner faceplate.
Use a flathead screwdriver to pry the faceplate off.| Press the square-corner faceplate into place.
Install the strike into the frame.
Drill pilot holes Z\,” x 3” deep, 2 places.
Reinforcement strike| Strike and reinforcement plate
Actual Size
Install the outside assembly.
CAUTION
If the bolt does not remain retracted throughout installation, locking and
unlocking could be reversed, resulting in an unsecured residence.
Install the outside assembly on the outside of the door.
Install the inside assembly.
CAUTION
If the cam is not in the correct position during installation, locking and
unlocking could be reversed, resulting in an unsecured residence.
4a Make sure the cam on the inside assembly is in the correct position.
4b Install the inside assembly on the inside of the door.
CAUTION
Bolt must remain retracted!
4c Secure the inside assembly with two screws.
If the screw holes are blocked by the cam, see step 4a.
4d Connect the cable to the inside assembly.
CAUTION
The connector fits only one way.
DO NOT FORCE!
4e Install the batteries.
4f Install the inside cover.
4g Secure the inside cover with two screws.
Test the Lock
Extend and then retract the bolt using the inside bolt throw.
**** Outside bolt throw should spin freely until a valid credential is presented.
Set up the lock.
Access online interactive instructions, user guide, warranty, and reference information.
Customer Service
1-877-671-7011
www.allegion.com/us © Allegion 2020
Printed in the U.S.A.
47327849 Rev. 10/20-a
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>