INR EDGE 20 Screen Wall Sway Stone Instruction Manual
- October 27, 2023
- INR
Table of Contents
INR EDGE 20 Screen Wall Sway Stone Instruction Manual
COMPONENTS
If needed
SAFETY REGULATIONS
This product complies with standard EN 14428. All glass is tempered safety glass according to EN12150.
Goggles are recommended to protect your eyes
Always use non-slip safety gloves
Use safety shoes during installation.
We recommend that two persons are present at the installation
Note! Always set the glass down on a soft foundation, since edges and corners are very delicate.
INSTALLATION
Screw fastenings should be made in concrete or other solid structure (a), wooden studs, wooden noggings (b) or in structures that have been tested and approved for fastenings, for example a sheet construction (c). Requirements for sealing apply in wet zones 1 and 2. See examples of construction at säkervatten.se.
Sealing materials must be fixed to the underlying layer and must be
waterproof, mould-resistant and age-resistant.
Did you know that it’s possible to glue the shower to the wall using our product SAFE-FIX Shower? Read more and watch the instruction clip at www.inr.se
WARRANTY
On all shower enclosures in the EDGE, ARC, EPIC and LINC series, we leave a 15-year warranty against any manufacturing defects. On BRIC and BASIC models, we leave a 5 year warranty. Sealing strips and magnetic strips are not covered by the warranty but are considered consumables. We recommend that the strips are replaced annually to remain fresh.
CARE ADVICE
Clean daily with water and a squeegee. To combat ingrained dirt, you are recommended to use a detergent intended for the purpose. Remember that sponges and abrasive paste cleaners can scratch both the glass as well as metal.
RECYCLING
- Wear protective goggles and gloves.
- Separate the sealing strip from the glass.
- Place some form of protection under the glass.
- Separate the profiles from the glass.
- Strike one corner with a hammer to break the glass.
- Take glass to the glass recycling facility
- Take aluminium and screws to the metal recycling facility.
- Take plastic strips and components to the plastic recycling facility.
INR Sverige
Kosterögatan 15
211 24 Malmö
Sverige
Tel 0200-38 40 40
info@inr.se
www.inr.se
INR Norge
Fjordgaten 13 A
3125 Tønsberg
Norge
Tel +47 33 33 02 00
info@inr.no
www.inr.no
INR Danmark
Kosterögatan 15
211 24 Malmö
Sverige
Tel +45 33 60 31 10
info@inr.dk
www.inr.dk
INR Suomi
Itsehallintokuja 4
02 600 Espoo
Suomi
Tel 010 209 3300
info@inr.fi
www.inr.fi
References
- Nyt badeværelse - Oplev ikoniske, nordiske rum her - INR
- Kylpyhuoneen sisustus ja suihkukalusteet | INR
- Baderomsinnredning - Utforsk nordisk kvalitet og design - INR
- INR Badrum - Hitta inspiration och inredning till ditt badrum
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>