INR ARC 4 Shower Wall Frame Instruction Manual
- June 4, 2024
- INR
Table of Contents
ARC 4 Shower Wall Frame
ICONIC NORDIC ROOMS
ARC 4 Frame
Art.nr 804 XXX XX
COMPONENTS
SAFETY REGULATIONS
14428:2005+A1:2008| This product complies with standard EN 14428. All glass is
tempered safety glass according to EN12150.
---|---
| Goggles are recommended to protect your eyes.
| Always use non-slip safety gloves.
| Use safety shoes during installation.
| We recommend that two persons are present at the installation.
| Note! Always set the glass down on a soft foundation, since the edges and
corners are very delicate.
INSTALLATION
Screw fastenings should be made in concrete or other solid structure (a),
wooden studs, wooden noggings (b), or in structures that have been tested and
approved for fastenings, for example, sheet construction (c). Requirements for
sealing apply in wet zones 1 and 2. See examples of construction at
säkervatten.se. Sealing materials must be fixed to the underlying layer and
must be waterproof, mold-resistant, and age-resistant.
Note! Patterned side out
Om fast glas > 400 mm, annars hoppa till steg 10. When fixed glass > 400 mm, otherwise go to step 10
WARRANTY
On all shower enclosures in the ARC, EPIC, and LINC series, we leave a 15-year
warranty against any manufacturing defects. On BRIC and BASIC models, we leave
a 5-year warranty. Sealing strips and magnetic strips are not covered by the
warranty but are considered consumables. We recommend that the strips are
replaced annually to remain fresh.
CARE ADVICE
Clean daily with water and a squeegee. To combat ingrained dirt, you are
recommended to use a detergent intended for the purpose. Remember that sponges
and abrasive paste cleaners can scratch both the glass as well as metal.
RECYCLING
- Wear protective goggles and gloves.
- Separate the sealing strip from the glass.
- Place some form of protection under the glass.
- Strike one corner with a hammer to break the glass.
- Take glass to the glass recycling facility
- Take aluminum and screws to the metal recycling facility.
- Take plastic strips and components to the plastic recycling facility.
INR Norge
Fjordgaten 13 A
3125 Tønsberg Norge
Tel +47 33 33 02 00
References
- INR – Skandinaviske badeværelser
- INR Kylpyhuoneen sisustus – Luo oma kylpyhuoneesi
- Baderomsinnredning og dusj – Skap badet ditt
- Badrumsinredning från INR – Skapa ditt badrum
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>