INR ARC 13 Original Shower corner Installation Guide
- June 4, 2024
- INR
Table of Contents
ARC 13 Original Shower corner
Installation Guide
Accepted
monteringsanvisning
2016:1| **INR SVERIGE AB
Kosterögatan 15
SE-211 24 Malmö 13
EN 14428:2005+A1:2008| ICONIC
NORDIC
ROOMS**
---|---|---
COMPONENTS
SAFETY REGULATIONS
**| This product complies with standard EN 14428.
All glass is tempered safety glass according to EN12150.
---|---
| Goggles are recommended to protect your eyes.
| Always use non-slip safety gloves.
| Use safety shoes during installation.
| We recommend that two persons are present at the installation.
| Note!** Always set the glass down on a soft foundation, since the edges
and corners are very delicate.
INSTALLATION
Note!
Patterned side out
Screw fastenings should be made in concrete or other solid structure (a),
wooden studs, wooden noggings (b), or in structures that have been tested and
approved for fastenings, for example, sheet construction (c). Requirements for
sealing apply in wet zones 1 and 2. See examples of construction at
säkervatten.se. Sealing materials must be fixed to the underlying layer and
must be waterproof, mold-resistant, and age-resistant.
Note! Patterned side out
WARRANTY
On all shower enclosures in the ARC, EPIC, and LINC series, we leave a 15-year
warranty against any manufacturing defects. On BRIC and BASIC models, we leave
a 5-year warranty. Sealing strips and magnetic strips are not covered by the
warranty but are considered consumables. We recommend that the strips are
replaced annually to remain fresh.
CARE ADVICE
Clean daily with water and a squeegee. To combat ingrained dirt, you are
recommended to use a detergent intended for the purpose. Remember that sponges
and abrasive paste cleaners can scratch both the glass as well as metal.
RECYCLING
-
Wear protective goggles and gloves.
• Take glass to the glass recycling facility -
Separate the sealing strip from the glass.
• Take aluminum and screws to the metal recycling facility. -
Place some form of protection under the glass.
-
Strike one corner with a hammer to break the glass.
• Take plastic strips and components to the plastic recycling facility.
INR Sverige
Kosterögatan 15
211 24 Malmö
Sverige
Tel 0200-38 40 40
info@inr.se
www.inr.se| INR Norge
Fjordgaten 13 A
3125 Tønsberg
Norge
Tel +47 33 33 02 00
info@inr.no
www.inr.no| INR Danmark
Kosterögatan 15
211 24 Malmö
Sverige
Tel +45 33 60 31 10
info@inr.dk
www.inr.dk| INR Suomi
Itsehallintokuja 4
02 600 Espoo
Suomi
Tel 010 209 3300
info@inr.fi
www.inr.fi
---|---|---|---
References
- INR – Skandinaviske badeværelser
- Baderomsinnredning og dusj – Skap badet ditt
- Badrumsinredning från INR – Skapa ditt badrum
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>