INR ARC 17 Wall Bathtub Instructions

June 4, 2024
INR

ARC 17 Wall Bathtub
Instruction ManualINR ARC 17 Wall Bathtub![INR ARC 17 Wall Bathtub

COMPONENTS

INR ARC 17 Wall Bathtub - Figure 1

SAFETY REGULATIONS

| This product complies with standard EN 14428.
All glass is tempered safety glass according to EN12150.
---|---
| Goggles are recommended to protect your eyes.
| Always use non-slip safety gloves.
| Use safety shoes during installation.
| We recommend that two persons are present at the installation.
| Note! Always set the glass down on a soft foundation,  since the edges and corners are very delicate.

INSTALLATION

INR ARC 17 Wall Bathtub - Figure 2
Note! Patterned side out

INR ARC 17 Wall Bathtub - Figure 3|

Screw fastenings should be made in concrete or other solid structure (a), wooden studs, wooden noggings (b), or in structures that have been tested and approved for fastenings,  for example, a sheet construction (c). Requirements for sealing apply in wet ones 1 and 2. See examples of construction at säkervatten.se.
Sealing materials must be fi xed to the underlying layer and must be waterproof, mold-resistant, and age-resistant.

INR ARC 17 Wall Bathtub - Figure 5| INR ARC 17
Wall Bathtub - Figure 6
---|---
INR ARC 17 Wall Bathtub - Figure 7

WARRANTY

On all shower enclosures in the ARC, EPIC, and LINC series, we leave a 15-year warranty against any manufacturing defects. On BRIC and BASIC models, we leave a 5-year warranty. Sealing strips and magnetic strips are not covered by the warranty but are considered consumables. We recommend that the strips are replaced annually to remain fresh.

CARE ADVICE

Clean daily with water and a squeegee. To combat ingrained dirt, you are recommended to use a detergent intended for the purpose. Remember that sponges and abrasive paste cleaners can scratch both the glass as well as metal.

RECYCLING

1. Wear protective goggles and gloves.| • Take glass to the glass recycling facility
---|---
2. Separate the sealing strip from the glass.| • Take aluminum and screws to the metal recycling facility.
3. Place some form of protection under the glass.| • Take plastic strips and components to the plastic recycling facility.
4. Strike one corner with a hammer to break the glass.

INR Norge
Fjordgaten 13 A
3125 Tønsberg
Norge
Tel +47 33 33 02 00
info@inr.no
www.inr.no

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals