FLOS 09.9084.BW The Fast Track Spot 150 Casambi Integrated Instruction Manual

: June 6, 2024
: FLOS

Table of Contents

IMPORTANT SAFETY INSTRUCTIONS
INSTRUCTIONS OF INSTALLATION AND USE ATTENTION!
CLEANING INSTRUCTIONS
TECHNICAL DATA
SPOTS INSTALLATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

FLOS 09.9084.BW The Fast Track Spot 150 Casambi Integrated Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS

Installation by a qualified electrician only.
Luminaire/ Track! Gateway should only be used with Flos accessories or components.
System is intended for installation in accordance with National Electric Code, and local regulations.
Luminaires intended for surfaces that are not normaly flammable.
Do not install this track in damp or wet locations.
Do not install any luminaire assembly closer than 6 inches from any curtain, or similar combustible material.
Do not install any part of the track system less than 5 feet above the floor
Disconnect electrical power before adding to or changing the configuration of the track.
Do not attempt to energize anything other than lighting track luminaires on the track.
To reduce the risk of fire and electric shock, do not attempt to connect power tools, extension cords, appliances, and the like to the track.
Do not install concealed or extended through building walls.
Do not connect track to more than one branch circuit.
Proper method of mechanically securing and electrically connecting each electrical fitting to the track or to another electrical fitting shall be clearly described.
Use only with Class 2 Power Unit

INSTRUCTIONS OF INSTALLATION AND USE ATTENTION!

The safety of the device can only be guaranteed on condition that to be respected the following instructions, both stages of installation and use therefore it is highly recommended to keep them.
WARNING: To carry out the installation, and whenever an operation in the device is carried out, make sure of having disconnected the electric power. The device cannot be in any case modified or forced, any modification might jeopardize the safety system making it dangerous. FLOS declines any responsibility on modified products. The device has been designed for inside. IP20 Ordinary.
Luminaire class III: Device with a very low tension of safety. The conformity with the standard is only guaranteed if the device is powered by a safety transformer according to the standard Cenelec EN 60472 or by equal safety sources. Devices with a very low voltage of safety (BTS) marked, do not have to be connected to drivers with earth socket.
Luminaires intended for direct assembly on surfaces that are normally flammable. Use an appropiate equipment and in agreement with the standard.
The luminaire should only be used with Flos accessories or components.
The symbol shown on the device indicates that the product must be eliminated differently from the rest of the urban waste.

CLEANING INSTRUCTIONS

Use only a soft cloth to clean the appliance. For stubborn dirt, dampen the cloth with water and dean only the reflector and the outer part of the appliance. Do not clean or touch the LED/light source in any way.
Warning: do not use alcohol or other solvents.

The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.

Warning Instructions