anslut 422490 Christmas Train Instruction Manual
- June 6, 2024
- anslut
Table of Contents
anslut 422490 Christmas Train
SAFETY INSTRUCTIONS
Read the User Instructions carefully before use!
Save these instructions for future reference.
NOTE:
This is not a toy. Only for decorative use. Store out of the reach of
children. For indoor use only.
- An adult must perform connections, assembly of accessories and battery replacement.
- Carefully unpack the product from the box and remove the plastic bag. Remove all packaging material. Never lift the product using the accessories, band or figures.
- Never pull the figures, wheels, cable or accessories.
IMPORTANT:
- An adult must replace the batteries.
- Do not mix old and new batteries.
- Do not mix alkaline batteries with normal batteries or rechargeable batteries (NiCd).
- Batteries must not be burned – risk of explosion.
- Do not attempt to charge non-rechargeable batteries.
- Insert the batteries with the correct polarity and according to manufacturer’s instructions.
- Remove the batteries and store in a dry, cool place when the product is not in use.
- Always remove old or weak batteries.
TECHNICAL DATA
-
Batteries
4×1.5 V AA -
LED
2x 0.045 W -
Dimensions
(/J 137 cm
OPERATION
Inserting the batteries
The battery compartment is located under the roof of the locomotive. Remove
the screw holding the roof and insert 4 x 7.5 V AA batteries. The batteries
are sold separately.
NOTE:
Use alkaline batteries for best results. Only use new batteries of the
correct type. Remove the batteries when the product is not going to be used
for some time. If the product does not work normally, check that the batteries
are not spent and have been inserted correctly. Test using new batteries.
Assemble the track and start the locomotive
-
Replace the locomotive roof and secure it with the screw.
-
Place the whistle in the hole on top of the locomotive and fit the front pilot. Apply the enclosed decals to the light fields on the sides of the locomotive.
-
Connect the track sections to form a ring by pressing the pins at the end of one track section into the holes in the next section. Place the track on a flat, firm surface.
-
Place the locomotive facing anti-clockwise on the track and check that all the wheels rest properly on the track.
-
Couple the locomotive and wagons.
-
Make sure that the locomotive and wagons are positioned correctly on the track.
-
Select the required pattern with the switch. The locomotive can be run with or without music, depending on in which way the switch is moved. The locomotive is switched off when the switch is in the middle position.
-
The train runs, with sound, lights and music for 15 minutes, stops for 5 minutes and then
starts again. -
Put the switch in the OFF position when the product is not in use. Remove the batteries if the product is not going to be used for some time.
Storage
When the product is to be put into storage – remove the batteries, the
whistle, buffer and track, and put the product in the packaging.