Garage Pro® Wet/Dry Vac blower modes | Support
- June 7, 2024
- Bissell
Table of Contents
To Use Blower
-
Attach hose to the Blower Outlet on the side of the vacuum
- Hose is “keyed” for Blower Outlet
- Press inward until keyed edge clears, then rotate to lock into place
-
When the power is turned on, the machine will function in the Blower Mode
-
To switch back to suction, simply remove the hose from the blower inlet, and put into the hose inlet
-
When hose attached to the Blower Outlet, the Suction Inlet will continue to have suction
Not Blowing
-
Check hose connection to be sure it is tight
- The hose must be attached to the blower inlet (right-side of machine, on top of the muffler), and securely locked into place by turning clockwise
-
If hose is attached correctly but not blowing
- Unplug electrical cord from outlet
- Pull dirt tank off and check filters
- Check for clog in hose
-
If still not blowing, please visit a BISSELL Authorized Service Center or Contact Us
-
Recipient Email
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>