Collingwood SL250 Low Voltage LED Path Light with Spike 3000K Instruction Manual
- October 27, 2023
- COLLINGWOOD
Table of Contents
SL250
PATH LIGHT
Instructions
INSTALLATION
-
Screw the light source (B) into the domed top (A).
*Copper and Brass finish only. -
Screw the pole (C) into the light source (B).
NOTE: Do not remove the cable from the pole. -
Holding the spike (D) upright feed the cable through the spike (D) and screw the pole (C) into the spike (D). Let the cable hang loose to avoid twisting it.
-
Push the unit into the ground.
-
Connect each product to a suitable Collingwood 24V constant voltage driver.
ADJUSTING THE BEAM ANGLE
The beam angle of the product can be adjusted from 60° to 110°. Rotate the
collar (E) over the light source to change the beam angle.
PARALLEL WIRING
The diagram above is an example with three LED units wired in parallel
Detailed wiring instructions are supplied with JB1 and JB5
LED UNITS IN DAMP
A suitable waterproof junction box or enclosure must be used to maintain the
IP rating of the product.
Failure to use a suitable junction box or enclosure will invalidate the
warranty
Collingwood Lighting recommend junction box JB1 or JB5 (examples above show 5x
LED units wired in parallel)
t +44 (0) 1604 495 151
f +44 (0) 1604 495 095
e sales@collingwoodgroup.com
w collingwoodlighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>