COLLINGWOOD LIGHTING SL240 Twin Bar Light Instructions
- June 3, 2024
- COLLINGWOOD LIGHTING
Table of Contents
COLLINGWOOD LIGHTING SL240 Twin Bar Light
INSTALLATION
- Screw the two mounting spikes supplied into the holes provided in the body of the product.
- Push the unit into the ground.
- Connect each product to a suitable Collingwood 350mA or 700mA constant current driver.
SERIES WIRING
LED UNITS IN DRY ENVIRONMENT (i.e. no moisture or condensation)
Junction boxes JB2 or JB4 (see overleaf) may be used for convenience.
Alternatively, wire the LED units in series to the LED driver using any
connectors suitable for SELV (Separated Extra Low Voltage)
- Connect red wire of first LED unit to + (plus) driver output terminal.
- Connect black wire of last LED unit to – (minus) driver output terminal.
- Connect black to red as shown, i.e. current flows ‘in’ through each red wire and ‘out’ through each black wire.
- The diagram above is an example with three LED units wired in series.
JB2 (IP68 to 2 metres)
JB4 (IP68 to 1.3 metres)
Detailed wiring instructions are supplied with JB2 and JB4
LED UNITS IN DAMP/WET ENVIRONMENTS
A suitable waterproof junction box or enclosure must be used to maintain the IP rating of the product.
Failure to use a suitable junction box or enclosure will invalidate the warranty
Collingwood Lighting recommend junction box JB2 or JB4 (examples above show 5x LED units wired in series)
t +44 (0) 1604 495 151 f +44 (0) 1604 495 095
esales@collingwoodgroup.com w
collingwoodlighting.com
See overleaf for wiring in a dry environment
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>