Rinnai 100000854-PCB Water Heater Installation Guide
- September 2, 2024
- Rinnai
Table of Contents
100000854-PCB Water Heater
“`html
Product Information
Specifications
-
Model: 888
-
Power Source: Natural Gas (NG) and Liquefied Petroleum Gas
(LPG) -
CO2 Levels: NG – 7.0% to 11.0%, LPG – 7.9% to 11.9%
-
O2 Levels: NG – 1.7% to 8.7%, LPG – 2.8% to 8.9%
Product Usage Instructions
Safety Precautions
Before operating the water heater, ensure to read and follow the
safety instructions provided on the label located on the side of
the unit.
Setting Up
-
Make sure the water heater is connected to the appropriate gas
source (NG or LPG). -
Adjust the gas settings based on your preferred gas type (NG or
LPG). -
Set the desired temperature using the temperature adjustment
controls.
Operating the Water Heater
-
Turn on the water heater using the designated power
switch. -
Monitor the CO2 and O2 levels periodically to ensure they are
within the safe ranges. -
Adjust the temperature settings as needed for optimal
performance.
FAQ
Q: What should I do if the CO2 or O2 levels are outside the
specified ranges?
A: If the CO2 or O2 levels exceed the specified ranges,
immediately turn off the water heater and ventilate the area.
Contact a professional for assistance before resuming
operation.
Q: How often should I check the gas settings?
A: It is recommended to check and adjust the gas settings
whenever switching between NG and LPG or when experiencing any
performance issues.
“`
0 1
SEt dES
t
t
PAS bAd
· ·
SEt
SEt
SEt
SEt
nG
nG
nG
LPG
LPG
In
In
In
In
Out Out
Out
nG LPG
In Out
888
888
A B
01A 01b
01A
01b
· ·
A
A B ……
AdJ
nL
LL
nL
nH
LH HS
WARNING Follow the label “For Your Safety Read Before Operating” located one
side of your water heater before starting the steps below.
WARNING
· · ·
NG LPG
CO2 7.0% – 11.0% 7.9% – 11.9%
O2 1.7% – 8.7% 2.8% – 8.9%
CAUTION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>