V-TAC VT-10126 LED Designer Hanging Light Instruction Manual
- June 20, 2024
- V TAC
Table of Contents
INSTRUCTION MANUAL
LED DESIGNER HANGING LIGHT
WEEE Number: 80133970
TECHNICAL DATA
| MODEL | VT-10126 |
|---|---|
| SKU | 23431, 23432 |
| POWER | 45W |
| INPUT VOLTAGE | A: 220-240V, 50Hz |
| CURRENT | 1050mA |
| LUMENS | 5500Lm |
| BEAM ANGLE | Sphere 120° |
| CRI | >80 |
| LIFE SPAN | 20,000 Hours |
| ON/OFF CYCLE | >15.000 Times |
| IP RATING | IP20 |
| MATERIAL | Metal+Silicone |
| DIMENSION | 620×1200 mm |
INTRODUCTION & WARRANTY
Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at the best. The warranty is valid for 2 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only.
WARNING
- Please make sure to turn off the power before starting the installation.
- Installation must be performed by a qualified electrician.
- For indoor use only
MULTI-LANGUAGE
MANUAL QR CODE
Please scan the QR code to access the manual in multiple languages.
*This product contains a light source of energy efficiency class
This marking indicates that this product should not be disposed of with other
household wastes.
Caution, risk of electric shock.
INSTALLATION DIAGRAM
INSTALLATION INSTRUCTIONS
- Mark the Position: Identify the appropriate position on the roof for installation.
- Drill the Hole: Drill a hole at the marked point. Then, insert the screw fixture into the hole.
- Attach the Bracket: Secure the bracket to the roof using screws.
- Wire Connection: Connect the wires as indicated in the diagram.
- Fix the Light Basement: Attach the light basement to the installed bracket.
- Adjust the Light Height: Adjust the height of the light by pulling it up or down as needed.
- Power On: Turn on the power and test the light to ensure proper installation.
HIGHT ADJUSTMENT FUNCTION
In case of any query/issue with the product, please reach out to us at:
support@v-tac.eu
For More products range, inquiry please contact our distributor or nearest
dealers.
V-TAC EUROPE LTD. Bulgaria, Plovdiv 4000, bul.L.Karavelow 9B
