COLLINGWOOD LIGHTING FL01 10W Colour Switchable Floodlight Instruction Manual

COLLINGWOOD LIGHTING FL01 10W Colour Switchable Floodlight

220-240V AC I 50-60Hz
LIVE – L (F) BROWN
NEUTRAL – N (N) BLUE
EARTH – YELLOW / GREEN

Installation

1. Set A – motion sensitivity, B – Lux level sensitivity, C – Time to required levels

2. Set required colour temperature for all units. Switch is located at the back of the floodlight under rubber cover.
   Use small screwdriver to lever the cover to access the switch.
   Note: Ensure the rubber cover is fitted correctly after selecting the colour temperature.

3. Fix the circular wall bracket to the wall. Screws and wall plugs are supplied.

4. Locate the floodlight over the circular wall bracket and tighten the screw to secure it in the required position. The aim of the floodlight can be adjusted by turning/tilting the unit.

5. Connect the flying lead to the mains supply. A suitable waterproof junction box or enclosure must be used to maintain the IP65 rating of the product.

6. Tighten the two side screws to clamp the floodlight in the required position.

Note: When the floodlight is switched on for the first time, you may notice a slight presence of condensation behind the glass.
The product is fitted with a breathable gland and any condensation will disappear after several hours of use.

Manual override the PIR sensor

To disable the PIR sensor, switch the floodlight on and off twice within 2 seconds. In this mode, the floodlight will remain illuminated until the PIR is activated again.

To reactivate the PIR sensor, switch the floodlight off for 10 seconds. When turned back on, the floodlight will be controlled by the PIR sensor.

Note: Each time the floodlight is switched on single flicker is visible.

FL01, FL02, FL03 with PIR sensor

Installation data

• Isolate the mains supply, prior to wiring.
• This unit must be wired by a qualified electrician or suitable competent person.
• The light source of this luminaire is not replaceable.
  When the light source reaches it’s end of life the whole luminaire shall be replaced.

50/60Hz
Input current| 0.088A| 0.165A| 0.145A
Input power| 10W| 20W| 30W
Power factor| >0.5| >0.5| >0.9
Inrush current| 10A/0.3ms| 11A/0.5ms| 30A/5μs
| Disposal of this product should be separate from household waste. Please separate these items from other types of waste and recycle them responsibly to promote the sustainable reuse of material resource. Household users should contact their local government office for details of where and how they can take these items for environmentally safe recycling.
---|---

3 year warranty

t +44 (0) 1604 495 151 f +44 (0) 1604 495 095 esales@collingwoodgroup.com w collingwoodlighting.com
Collingwood Lighting, Brooklands House, Sywell Aerodrome, Sywell, Northampton NN6 0BT, United Kingdom

Documents / Resources

| COLLINGWOOD LIGHTING FL01 10W Colour Switchable Floodlight [pdf] Instruction Manual
FL01, FL02, 10W Colour Switchable Floodlight, Switchable Floodlight, 10W Colour Floodlight, Floodlight, FL01
---|---
| COLLINGWOOD LIGHTING FL01 10W Colour Switchable Floodlight [pdf] Instruction Manual
FL01, FL02, FL03, FL01 10W Colour Switchable Floodlight, FL01, 10W Colour Switchable Floodlight, Switchable Floodlight, Floodlight

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>